Onkyo HT-R560 Owner Manual - Page 42
First Time Setup, Automatic Speaker Setup (Audyssey 2EQ - microphone
View all Onkyo HT-R560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
First Time Setup This section explains the settings that you need to make before using the AV receiver for the very first time. Automatic Speaker Setup (Audyssey 2EQ) With the supplied calibrated microphone, Audyssey 2EQ automatically determines the number of speakers connected, their size for purposes of bass management, optimum crossover frequencies to the subwoofer (if present), and distances from the primary listening position. Audyssey 2EQ then removes the distortion caused by room acoustics by capturing room acoustical problems over the listening area in both the frequency and time domain. The result is clear, well-balanced sound for everyone. Enabling Audyssey 2EQ allows you to also use Audyssey Dynamic EQ, which maintains the proper octave-to-octave balance at any volume level. (See page 76) Measurement Positions To create a listening environment in which several people can enjoy your home theater simultaneously, Audyssey 2EQ takes measurements at three positions within the listening area. A First measurement point This is the center point of the listening area, or the listening position. B Second measurement point The right side of the listening area. C Third measurement point The left side of the listening area. The distances between points 1 and 2 and points 1 and 3 must be at least 1 meter. From the examples below, choose the listening area that best matches yours and place the microphone accordingly when prompted. TV TV TV Using Audyssey 2EQ Notes: • If the AV receiver is muted, it will be unmuted automatically when the automatic speaker setup starts. • Automatic speaker setup cannot be performed while a pair of headphones is connected. • It takes about 10 minutes to complete the automatic speaker setup for three positions. Total measurement time varies depending on the speakers. • Do not connect or disconnect any speakers during the automatic speaker setup. 1 ON/STANDBY STANDBY TUNING PRESET ENTER MASTER VOLUME DOCK PHONES MULTI CH A SPEAKERS B DVD TONE VCR/DVR CBL/SAT AUX TAPE TUNER CD SETUP RETURN MOVIE/TV MUSIC GAME DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE CLEAR SETUP MIC AUX INPUT VIDEO L AUDIO R AV RECEIVER HT-R560 2, 6 SETUP MIC 1 Turn on the AV receiver. 2 SETUP MIC Put the speaker setup microphone at measurement point 1 (see left), and connect it to the SETUP MIC jack. TV TV TV TV TV TV : Listening area : Listening position 42 Notes: • For all measurements, the microphone capsule should point directly at the ceiling. • If there's an obstacle between the microphone and any speaker, the automatic setup will not work correctly. Set up the room as you would when enjoying a DVD. • Positioning the microphone close to where your ears would normally be will provide better results. You can adjust the height of the microphone by using a tripod or level table. • Do not attempt to hold the microphone in your hand during measurements as this will produce incorrect results.