Onkyo HT-R591 Owners Manual - Page 62

■ The AV receiver's remote controller doesn't control my iPod/iPhone Make sure your iPod/iPhone is properly inserted in - the Dock. If your iPod/iPhone is in a case, it may not connect properly to the Dock. Always remove your iPod/iPhone from the case before inserting it into the Dock. The iPod/iPhone cannot be operated while it's - displaying the Apple logo. Make sure you've selected the right remote mode. 54 When you use the AV receiver's remote controller, - point it toward your AV receiver. If you still can't control your iPod/iPhone, start - playback by pressing your iPod/iPhone model's Play button. Remote operation should then be possible. Try resetting your iPod/iPhone. - Depending on your iPod/iPhone, some buttons may - not work as expected. ■ The AV receiver unexpectedly selects my iPod/iPhone as the input source Always pause iPod/iPhone playback before selecting - a different input source. If playback is not paused, the Direct Change function may select your iPod/iPhone as the input source by mistake during the transition between tracks. ■ iPod/iPhone doesn't work properly Try reconnecting your iPod/iPhone. - Recording ■ Can't record On your recorder, make sure the correct input is - selected. To prevent signal loops and damage to the AV - receiver, input signals are not fed through to outputs with the same name (e.g., VCR/DVR IN to VCR/DVR OUT). USB Device Playback ■ Can't access the music files on a USB device Make sure the USB device is plugged in properly. - The AV receiver supports USB devices that support 68 the USB mass storage device class. However, playback may not be possible with some USB devices even if they conform to the USB mass storage device class. USB memory devices with security functions cannot 23 be played. Others ■ Standby power consumption In the following cases, the power consumption in 49 standby mode may reach up to a maximum of 34 W: - "HDMI Ctrl (RIHD)" setting is set to "On". (Depending on the TV status, the AV receiver will enter standby mode as usual.) - The "HDMI Through" setting is set to other than "Off". ■ The sound changes when I connect my headphones When a pair of headphones is connected, the listening - mode is set to Stereo, unless it's already set to Stereo, Mono, or Direct. ■ The speaker distance cannot be set as required The values entered may be automatically adjusted - with values best-suited for your home theater. ■ How do I change the language of a multiplex source Use the "Input Ch (Mux)" setting on the "Audio 44 Adjust" menu to select "Main" or "Sub". Appendix ■ The V functions don't work To use V, you must make an V connection and an 17 analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally. ■ When performing "Automatic Speaker Setup", the measurement fails and the message "Ambient noise is too high." is displayed. This can be caused by a malfunction in your speaker - unit. Check if the unit produces normal sounds. En-62