Onkyo HT-RC230 Owner Manual - Page 12
Connecting the Speaker Cables, Connecting a Powered Subwoofer, Using Banana Plugs - receivers
View all Onkyo HT-RC230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Connecting the Speaker Cables Screw-type speaker terminals Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 1/2" to 5/8"(12 to 15 mm) Using Banana Plugs • If you are using banana plugs, tighten the speaker terminal before inserting the banana plug. • Do not insert the speaker code directly into the center hole of the speaker terminal. Push-type speaker terminals Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the 3/8" to 1/2"(10 to 12 mm) speaker cables, and twist the bare wires tightly, as shown. The following illustration shows which speaker should be connected to each pair of terminals. Surround right speaker Surround left speaker Front right speaker A Front left speaker A Center speaker Speakers A Connecting a Powered Subwoofer Using a suitable cable, connect the AV receiver's SUBWOOFER PRE OUT jack to an input on your powered subwoofer, as shown. If your subwoofer is unpowered and you're using an external amplifier, connect the SUBWOOFER PRE OUT jack to an input on the amp. Front right speaker B Front left speaker B Speakers B En 12 LINE INPUT Powered subwoofer LINE INPUT