Onkyo HT-RC460 Owner Manual - Page 65
Controlling Zone 2 Components, En-65
View all Onkyo HT-RC460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Controlling Zone 2 Components ■ Operating on the AV receiver Input selector buttons ZONE 2 OFF MASTER VOLUME 1 To turn on Zone 2 and select an input source, press ZONE 2 followed by an input selector button within 8 seconds. Zone 2 turns on, the Z2 indicator lights on the AV receiver's display. To select the same source as the main room's, press ZONE 2 twice. "Z2 Sel: Source" appears on the AV receiver's display. 2 To turn off Zone 2, press OFF. The zone is turned off. ■ Operating on the remote controller To control Zone 2, you must press ZONE2 on the remote controller first. RECEIVER ZONE2 INPUT SELECTOR MUTING VOLR/X 1 Press ZONE2, then point the remote controller at the AV receiver and press RECEIVER. Zone 2 turns on, the Z2 indicator lights on the AV receiver's display. 2 To select an input source for Zone 2, press ZONE2, followed by an INPUT SELECTOR button. 3 To turn off Zone 2, press ZONE2, followed by RECEIVER. The zone is turned off. Adjusting the Volume for Zone 2 ■ Operating on the remote controller 1 Press ZONE2. 2 Use VOL R/X. ■ Operating on the AV receiver 1 Press ZONE 2 (the Z2 indicator on the AV receiver's display flash). 2 Use MASTER VOLUME control within 8 seconds. If your Zone 2 speakers are connected to a receiver or integrated amplifier in Zone 2, use its volume control to adjust the volume. Muting Zone 2 Advanced Operations ■ Operating on the remote controller 1 Press ZONE2 followed by MUTING. Tip • To unmute, press ZONE2 followed by MUTING again. Zone can also be unmuted by adjusting the volume. Note • Only analog input sources are output from the ZONE 2 LINE OUT jacks and ZONE 2 L/R terminals. Digital input sources are not output. If no sound is heard when an input source is selected, verify that the source is connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. Namely, if you have selected an FM station for the main room, that station will also be output in Zone 2. • When you have selected NET or USB as input selector, the last selector selected will be set for Main room and Zone 2. • When Zone 2 is activated and its input selector is selected, the power consumption of standby mode slightly increases. • While Zone 2 is on, V functions will not work. • When setting the AV receiver to standby mode while Zone 2 is active, the Z2 indicator is dimly lit. • "AUX", "EXTRA1" and "EXTRA2" cannot be selected as input sources for Zone 2. • When "AUX", "EXTRA1" or "EXTRA2" is the input source of Main room and Zone 2 is set to share the same source, no sound will be output from Zone 2. En-65