Onkyo HT-S3800 Operating Instructions - Page 30

5 Setup 5 Adjust the level of each channel using / . If you selected Manual, use / to switch speakers. The Auto setup will output test tones in the order shown on-screen: 1c.Channel Level Front L Center [ Front R [ Surround R [ Surround L [ Subwoofer [ 0dB 0dB] 0dB] 0dB] 0dB] 0dB] 1 Select 'Manual SP Setup' from the Setup. 2 Select 'Speaker Distance' from the Manual SP Setup menu. 1.Manual SP Setup a.Speaker Setting b.X.Over c.Channel Level d.Speaker Distance The Input Assign menu (CD) audio input terminal is assigned to CD under factory settings, but this can be changed to TV input. 2 4 33 Return Adjust the level of each speaker as the test tone is emitted. Note • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level of each speaker to 75 dB SPL (C-weighting/slow reading). • The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack. 6 When you're finished, press . You return to the Channel Level menu. Speaker Distance For good sound depth from your system, you need to specify the distance of your speakers from the listening position. The receiver can then add the proper delay needed for effective surround sound. • For the assignment of the digital signal inputs, see Selecting the audio input signal on page 16. Return 3 Adjust the distance of each speaker using / . (For the U.S.A., Canada and Latin America models) 1d.Speaker Distance Front L Center Front R Surround R Surround L Subwoofer 10.0 ft [ 10.0 ft ] [ 10.0 ft ] [ 10.0 ft ] [ 10.0 ft ] [ 10.0 ft ] Return You can adjust the distance of each speaker in 0.1 ft. increments. (For the other models) 1d.Speaker Distance Front L Center Front R Surround R Surround L Subwoofer 3.0 m [ 3.0 m ] [ 3.0 m ] [ 3.0 m ] [ 3.0 m ] [ 3.0 m ] Return You can adjust the distance of each speaker in 0.1 m increments. 4 When you're finished, press . You return to the Manual SP Setup menu. 1 Select 'Input Assign' from the Setup. Setup 1.Manual SP Setup 2.Input Assign 3.Auto Power Down 4.HDMI Setup Return 2 Select 'Analog Input' from the Input Assign menu. 2.Input Assign a.Analog Input 2a.Analog Input Analog CD Return Return 3 Select the desired input option for the (CD) audio input terminal. 4 When you're finished, press . You return to the Input Assign menu. 30