Onkyo HTSP908 Owner Manual - Page 19

DV-SP405_En.book Page 19 Tuesday, May 29, 2007 2:48 PM Connecting the DV-SP405-Continued Basic Setup The setup described here is a basic setup that allows you to play discs using just the supplied AV cable (RCA). In this setup, stereo audio is played through the speakers in your TV. TV VIDEO IN L R ANALOG INPUT Supplied AV cable DIGITAL COAXIAL AUDIO OUTPUT ANALOG L 405 R To power outlet Important: • This player is equipped with copy protection technol- ogy. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. (This player may also not be compatible with some combination TV/VCRs for the same reason; refer to the manufacturer for more information.) • When connecting to your TV as shown above, do not set the "Component Out" setting (page 46) to "Progressive". 1. Connect the VIDEO OUTPUT and ANALOG AUDIO OUTPUT L/R jacks to a set of A/V inputs on your TV. Use the supplied AV cable (RCA), connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound. See page 21 if you want to use a component, SVideo cable or SCART cable for the video connection. 2. Oceanian and European models: Connect the supplied AC power cord to the AC INLET, then plug into a power outlet. North American model: Connect the power cord to power outlet. Notes: • Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel STANDBY/ON button, or the remote controller, and wait of the "OFF" message to disappear from the player's display. • For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers. 19