Onkyo TX-DS575x Owner Manual - Page 5
Before operating this unit - remote
View all Onkyo TX-DS575x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Before operating this unit 10kHz 9kHz AM FREQUENCY STEP ANTENNA WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE DO NOT OPEN NE PAS OUVRIR R L V L S DVD I N AM VIDEO 3 R I N L FRONT SPEAKERS A R VIDEO 2 FM 75 GND VIDEO 1 L R PHONO CD (PLAY) I N TAPE OUT (REC) R V L I N CENTER SPEAKER I N FRONT OUT R L MONITOR OUT SURROUND S R L SUBWOOFER PRE OUT CENTER SUB WOOFER MULTI CH INPUT DIGITAL INPUT COAXIAL 2 FRONT SPEAKERS B COAXIAL 1 L OPTICAL 2 OPTICAL 1 R SURROUND SPEAKERS L R REMOTE CONTROL AV RECEIVER MODEL NO. TX-DS575X 10kHz 9kHz AM FREQUENCY STEP 220-230V 120V VOLTAGE SELECTOR AC OUTLETS SWITCHED TOTAL 100W MAX. 220-230V 120V VOLTAGE SELECTOR 1 2 3 Remote control sensor STANDBY indicator TX-DS575X 30˚ 30˚ approx. 5 m (16 feet) Setting the AM tuning step frequency (Worldwide models only) Worldwide models are equipped with a switch that controls the AM band tuning steps. Please set this switch to match the AM band tuning step frequency in your area. U.S.A. and Canada : 10 kHz Other areas : 9 kHz Setting the Voltage selector (Worldwide models only) Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit. 1. Determine the proper voltage for your area: 220-230 V or 120 V. 2. If the preset voltage is not correct for your area, insert a screw- driver into the groove in the switch. Slide the switch all the way to the right (120 V) or to the left (220-230 V), whichever is appropriate. Installing the remote controller batteries 1. Remove the battery compartment cover by pressing and sliding it out. 2. Insert two AA (R6- or UM-3)-size batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (-) symbols) inside the battery compartment. 3. After batteries are installed and seated correctly, replace the compartment cover. Notes • Do not mix new batteries with old batteries or different kinds of batteries. • To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time. • Remove dead batteries immediately to avoid damage from cor- rosion. If the remote controller doesn't operate smoothly, replace both the batteries at the same time. • The life of the batteries supplied is about six months but this will vary depending on usage. Using the remote controller Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller. Notes • Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller. • Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference. • Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries. • Make sure the audio rack doors do not have colored glass. Plac- ing the unit behind such doors may prevent proper remote controller operation. • If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. 5