Onkyo TX-DS989 Owner Manual - Page 49
Enjoying music or videos in the remote zone
View all Onkyo TX-DS989 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Enjoying music or videos in the remote zone POWER ON STANDBY/ON STANDBY POWER ON OFF DISPLAY ZONE 2 (GRN ) REC ( RED ) DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 TAPE 1 TAPE 2 AM FM PHONO C D CLEAR MASTER VOLUME OPEN/CLOSE PHONES AV RECEIVER TX-DS989 Zone 2 Off AUDIO TRACK MUTING DISC VOL REC OPEN/CLOSE DVD CD T1 T2 TUN PH V1 V2 V3 V - STEREO 1 DIRECT 2 SURROUND THX 4 5 Re-EQ 7 CH SEL 8 LATE NIGHT DIMMER + 10 0 DSP 3 DSP 6 LEVEL + 9 LEVEL - ENT HOME THEATER CONTROLLER RC-390M Input selector buttons Controlling the TX-DS989 from the remote zone 1. Aiming at the remote sensor, press the POWER ON button on the remote controller. Note: Be aware that if you start using the system in the remote zone (Zone 2) while a recording is going on in the main zone, the recording is aborted. 2. Press the appropriate input selector button on the remote controller to select the desired source. 3. Adjust the volume on the power amplifier to the desired level. Controlling the TX-DS989 without the remote controller 1. Press the Zone 2 button on the TX-DS989. 2. Select a source. After pressing the Zone 2 button, you must press an input source button within 8 seconds. To select the same source as that selected for the main zone, press the Zone 2 button twice in succession. The indicator above the selected input source will light green. Adjust the volume in the remote zone as desired. Ex.: When the Zone 2 button is pressed twice Ex.: When the Zone 2 button and then VIDEO 4 button are pressed Notes: • If the Zone 2 button was pressed twice so that the same source is being played in the main and remote zones, then changing the input source in the main zone also changes the input source for the remote zone. • In the remote zone, you can only play the source in the 2channel mode. You cannot play the source in the remote zone in the surround mode. • If the Rec Out button is pressed in the main room while someone is using the system in the remote zone, the Zone 2 function will be deactivated and the source will turn off in the remote zone. • The Zone 2 terminal is an analog output. Digital signals are not output. If no sound is heard from the selected input source, check if the component is connected to the analog inputs. • Please note that some third-party multi-room system components may not be fully compatible with the Onkyo multi-room system components. • If you are not using the system in the remote zone, always 49 press the Zone 2 button and then the Off button to turn the Zone 2 function off.