Onkyo TX-SR444 User Manual - Page 10
Setting Up - test
View all Onkyo TX-SR444 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Step 2: Setting Up Operation: Use the remote controller of this unit to operate the menus shown on the TV screen. To display the guidance, you need to make HDMI connection between the unit and TV. Select the item with the cursor buttons of the remote controller and press ENTER to confirm your selection. To return to the previous screen, press RETURN. 1. Place the speaker setup microphone. Before starting the procedure, refer to the figure and place the supplied speaker setup microphone at the measurement position . 1 Turning the Power On Connect the power cord to the outlet (). Press z ON/ STANDBY on the main unit or z RECEIVER on the remote controller to turn the unit on or to standby mode. ●● When the unit is turned on, a large instantaneous current may flow affecting functionality of the computer and other devices. It is recommended to use a separate outlet from that for the computer or such other sensitive devices. ¼¼Taiwanese models include removable power cords. Connect the power cord to AC INLET of the unit and then connect to the outlet. Always disconnect the outlet side first when disconnecting the power cord. 2 Making Automatic Speaker Setting The AccuEQ Room Calibration function, our proprietary technology, measures the test tone coming from each speaker with the supplied speaker setup microphone, setting of the number of speakers, volume level, each speaker's optimum crossover frequencies, and distance from the primary listening position, and also enables correction of distortion caused by the acoustic environment of the room. ●● You cannot return to the previous screen during speaker setup, even if you press RETURN. Listening area Measurement position with microphone ¼¼Correct measurement will not be possible if the microphone is held by hand. Measurement is not possible if headphones are being used. ¼¼The subwoofer sound may not be detected since it is extremely low frequencies. Set the subwoofer volume to around the half of its maximum volume and make its frequency to the maximum level. ¼¼Measurement may be interrupted if there is ambient noise or radio frequency interference. Close the window and turn off the home appliance and fluorescent light. 2. Connect the speaker setup microphone to the SETUP MIC jack of the unit. SETUP MIC jack Speaker setup microphone En-10