Optoma HD82 User Manual - Page 13

Powering On/Off the Projector

Get Optoma HD82 PDF manuals and user guides View all Optoma HD82 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

English Installation Powering On/Off the Projector Powering On the Projector 1. Remove the lens cap.  2. Securely connect the power cord and signal cable. When connected, the power led will turn red. 3. Turn on the lamp by pressing " " button on the side of the projector or on the remote control. The power led will now flash blue. The startup screen will display in approximately 30 seconds. The first time you use the projector, you can select your preferred language from quick menu after the startup screen display. 4. Turn on your source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically and will display on the screen. If not, push menu button and go to "SETUP". Make sure that the "Source Lock" has been set to "Off". ▀■ If you connected multiple sources at the same time, press the "Source" key on the remote control to switch between inputs. Noottee Turn on the projector first and then select the signal sources. POWER LAMP TEMP STANDBY 1 POWER LAMP TEMP 2 STANDBY 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
English
±³
Installation
POWER
TEMP
LAMP
STANDBY
Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the power led will turn red.
3. Turn on the lamp by pressing
“
”
button on the side of the
projector or on the remote control. The power led will now
flash blue.
The startup screen will display in approximately 30 seconds.
The first time you use the projector, you can select your
preferred language from quick menu after the startup screen
display.
4. Turn on your source that you want to display on the screen
(computer, notebook, video player, etc). The projector will
detect the source automatically and will display on the
screen. If not, push menu button and go to “SETUP”. Make
sure that the “Source Lock” has been set to “Off”.
▀
■
If you connected multiple sources at the same time, press
the “Source” key on the remote control to switch between
inputs.
Powering On/Off the Projector
Turn on the projector
first and then select the
signal sources.
1
N
ote
N
ote
2