Optoma TX700 User Manual - Page 37
Replacing the lamp - bulb
UPC - 796435111212
View all Optoma TX700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Appendices Replacing the lamp The projector will detect the lamp life itself. It will show you a warning message " " When you see this message, change the lamp as soon as pos- Warning: Lamp sible. compartment is hot! Make sure the projector has been cooled down for at least 30 Allow it to cool down minutes before changing the lamp. before changing lamp! 1 2 3 4 Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped. Lamp Replacing Procedure: 1. Switch off the power to the projector by pressing the Power/ Standby button. 2. Allow the projector to cool down at least 30 minutes. 3. Disconnect the power cord. 4. Use a screwdriver to remove the screw from the cover. 5. Push up and remove the cover. 6. Remove the 2 screws from the lamp module. 7. Pull out the lamp module. To replace the lamp module, reverse the previous steps. 37 ... English