Oreck Table Top Owners Guide - Page 4

IMPORTANT NOTES: q Your air purifier works best if you leave it in operation all the time. q Place or mount the air purifier near a standard electrical outlet. Do not block either the air intake or outlet grill. q Never place your air purifier on soft surfaces (such as bed, sofas or carpet), near computers or next to sources of heat (such as stove tops, ovens, etc.) q Make sure the front grill is securely locked in place. q A safety switch is installed behind the grill of your electronic air purifier. If the grill is not properly secured in place, the unit will not operate. If your unit fails to operate, remove the front grill and reinstall it, being sure that the lower right-hand side of the grill (next to the control panel) is firmly locked in place. q Plug the power cord into the nearest available standard electrical outlet. (See data label on bottom of your air purifier for electrical specifications and power consumption.) every two months or as needed. IMPORTANT: DO NOT wash the charcoal odor absorber. Replace, if necessary. Replacing Cell After Cleaning 1. Snap in the charcoal odor absorber. (fig. 3) 2. Slide in the pre-filter. (fig. 4) 3. Slide cell into cabinet, using handles. (fig. 2) 4. Replace front grill. Unit is now ready for operation. (fig. 1) NOTE: An occasional "arcing" sound is normal when operating the unit immediately after cleaning the cell and should stop after a few minutes of operation. Replacing Fragrance Cartridge 1. Open cartridge compartment by sliding the compartment release switch. (fig. 5) 2. Remove fragrance disk from center of cartridge and replace with a new one. (fig. 6) q Do not use an extension cord to supply power to your air purifier. 3. Close compartment until it locks. (fig. 7) Cleaning The Cabinet You can clean the air purifier cabinet with mild, non-abrasive cleanser and a soft cloth. IMPORTANT: Unplug the unit from its electrical power source. Do not spray cleansers or furniture polish into the louver or grill areas. Collector Cell Indicator light is green under normal operation and flashes red when the cell requires cleaning. To clean, proceed as follows: The red "WASH CELL" light will flash or illuminate when it is time to clean your cell. However, it is recommended that every four to eight weeks or if snapping sounds become frequent, clean your electronic air purifier. Your electronic air purifier is still filtering the air when the red light illuminates. Cleaning your electronic air purifier is a snap too... and a must for efficient operation. 1. Turn the unit off and unplug it from the electric power source. If wall mounted, remove unit from wall. 2. Remove front grill by unscrewing the retainer screw under the grill on the cabinet bottom. (fig. 1) 3. Pull the cell out of the cabinet by using the two small handles on the front of the cell. (fig. 2) 4. Snap off the charcoal odor absorber from the back of the cell. Change as necessary for continued odor removal. (fig. 3) 5. Slide off pre-filter. This can be cleaned with the cell and reused. (fig. 4) NOTE: Handle the electronic cell with care. Damaged metal plates and/or broken wires will cause the air purifier to malfunction. (Do not wash charcoal odor absorber; it is disposable.) Cleaning with Assail-A-Cell® Cell Cleaner: 6. Using Assail-A-Cell® Cleaner, thoroughly saturate the cell and prefilter. Be sure to spray between each cell plate and cover every surface. Allow product to soak for a few minutes, not allowing it to dry. Rinse thoroughly with water. For extremely heavy deposits, repeat the process. IMPORTANT: Dry the collection cell thoroughly outside of the air purifier before reinstalling it into the air purifier. Ensure that all areas including corners and areas that may trap water are dry before reinstalling into the air purifier. DO NOT place a wet or damp collection cell in the air purifier. NOTE: One fragrance cartridge is included. Troubleshooting Guide Service problems that appear to be major can often be solved easily. You can be your own troubleshooter by reviewing the chart below. It pinpoints problems and how to correct them. Remember, check the simple things first. PROBLEM CHECK UNIT DOES NOT TURN 1. Power Cord ON 2. Selector Switch 3. Front Grill INDICATOR LIGHT ON Ionizer/collector cell UNIT IS FLASHING RED OR HAS TURNED RED UNIT DOES NOT REMOVE POLLUTANTS UNIT SPARKS, CRACKLES AND POPS Ionizer/collector cell Ionizer/collector cell DOES NOT REMOVE ODOR UNIT STILL DOES NOT OPERATE PROPERLY Old Charcoal Odor Absorber Check all the above points WHAT TO DO 1. Plug in power cord 2. Set selector switch for desired blower speed. 3. Reinsert front grill until it is flush with cabinet front. Tap grill lightly, if necessary, to fully insert. Wash ionizer/collector cell. Make sure it is thoroughly clean & dry before re-installing it. Wash cell A little is normal. Make sure the cell is thoroughly dry before re-installing it. If it persists, clean cell. If that doesn't help, cell may be damaged and needs replacing. Replace Charcoal Odor Absorber. Return unit to the Service Center. ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER. CALL CUSTOMER SERVICE HOT LINE US:1-800-989-3535 Canada: 1-888-676-7325 Replacing the Charcoal Odor Absorber (Optional) In addition to air purification, your Oreck provides the additional benefit of odor removal. The odor removal function is optional. Your Oreck Air Purifier will continue to remove harmful airborne particles with its permanent electronic collector cell even if you choose not to use the optional charcoal odor absorber. Odor absorption effectiveness will gradually deteriorate over time unless the charcoal odor absorber is replaced. While every environment is different, Oreck suggests that the charcoal odor absorber be replaced Whenever calling, please be sure to have your model and serial number from data plate. Accessories ITEM 1. Pre-Filter 2. Ionizer/Collector Cell 3. Charcoal Odor Absorber (Set of 4) 4. Wall Mounting Kit 5. Oreck Fresh Air® Scent Cartridges Spring Mulberries®, 8pk. Blooming Jasmine®, 8pk. PART # 7780-8041 09-5510-7065 AT4PK7 8660-0201 FA2PK FA3PK © 2006 Oreck Holdings, LLC. All Rights Reserved. All word mark, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC. 4 3323-3018 REV H 01/06 ECN# R-8239, R-8240