Oreck U2420RS Owners Guide - Page 4

1 2 Upper 3 4 5 Handle 6 7 8 9 ENFONCEZ JUSQU'À ENTENDRE UN BRUIT PRESIONE HASTA ESCUCHAR UN CHASQUIDO DE SUJECIÓN fig. 1 fig. 2 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward. Slide upper handle section over matching section of the connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose. General Information Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On (l) - OFF(O) switch on top of base when ready to operate. Up-Position Lock fig. 3 Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock. NOTE: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation. For Easy Power Cord Storage fig. 4 Wrap power cord around cord hook on handle and cord hook on connector. Secure to "U" shaped part on plug. To Replace Filter Dust Bag WARNING: Unplug cord from electrical outlet before servicing. fig. 5 fig. 6 fig. 7 Unzip outer bag completely. Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward. Gently pull bag cardboard collar upward out of the bag dock. Bag Installation fig. 8 fig. 9 Slide the cardboard collar completely into bag dock door. Firmly push bag dock door with both thumbs on indication point until it snaps. Using An Oreck Fresh Air® Tab Your ORECK XL vacuum cleaner has a special FRESH AIR® tab pocket. This light-colored pocket is located inside the vinyl bag in the area where the paper disposable bag attaches to the intake tube. Insert tablet in pocket. 4