Oster 1.7 Liter Cordless Kettle Instruction Manual - Page 4
Clean your electric kettle before first use, Using your Detachable Base Electric Kettle, Filter
View all Oster 1.7 Liter Cordless Kettle manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Clean your electric kettle before first use 1. W ash the inside of the kettle and lid with mild detergent and water. Rinse each thoroughly. Do not immerse the kettle or power base in water or any other liquid. These items are not dishwasher safe. 2. F ill the electric kettle with fresh water to the "MAX" water level mark on water window. Boil the water, following the directions below for use of your specific kettle. 3. W hen the water and unit have cooled, discard the water. Rinse with cold water and repeat. 4. Y our electric kettle is now ready for use. Using your Detachable Base Electric Kettle 1. P osition the power base on a flat, heat resistant surface, as close as possible to a power outlet. 2. F ollow cord routing in power base according to exit patterns. Proper cord routing will result in the power base laying flat when kettle is placed on base. DO not operate kettle if power base is not flat. If power base is not flat, remove kettle from power base and repeat cord placement instructions. 3. T o fill with water, open the lid. Fill the electric kettle with water to the desired level. NOTE: Do not exceed the "MAX" water level mark indicated on the electric kettle. 4. P lace kettle back on power base. Plug the electric cord into an electric outlet. Turn the switch ON by pushing down on the on/off switch. The on/off light will illuminate to indicate the unit is on. The water will heat and the electric kettle will switch off automatically when the water has boiled. NOTE: Ensure the ON/OFF switch is clear of obstructions and the lid is firmly closed. The electric kettle will not turn off automatically if the ON/OFF switch is constrained, or if the lid is left open. 6 BVST-EK18 Series_13ESM1.indd 6-7 5. Carefully lift the kettle from the power base and pour the hot water. NOTE: The kettle will not re-boil until the on/off switch is again switched ON. Wait 15-20 seconds, allowing kettle to cool down, then switch ON. Filter removal / cleaning / refitting Important: The kettle must be switched off, disconnected from the power outlet and allowed to cool down completely prior to removing or refitting the filter. Do not use excessive force, as this might damage the filter or the lid. 1. E mpty the kettle and open lid. 2. H old lid open with one hand and grip the top part of the filter with index finger and thumb. Caution: Keep fingers clear of mesh. Pressing into mesh may damage filter. 3. T o remove filter simply pull upwards. This will disengage the filter from its guides (see illustration). 4. T o clean the filter, rinse under a tap while brushing it gently with a soft brush. 5. T o refit filter, once again hold lid open with one hand and filter with index finger and thumb. Gently push filter back into the kettle until it fits snugly in its guides. Be sure to fit the bottom lip of the filter snugly in the center guide. This will center the filter in the spout, ensuring a good fit. Remove 6. R inse out kettle with fresh water and it's ready for use. Refit 7 4/22/13 9:04 AM