Palm 3263NA Quick Start Guide - Page 2

EN Before You Start... BYSeotafuortr.e.. Installation If you have purchased TomTom NAVIGATOR on a TomTom memory card, insert the memory card in your device. Then go to step 4 below. If you are installing TomTom NAVIGATOR from a DVD do the following: 1. Connect your device to your computer, or insert the memory card you are using into a card reader/writer attached to your computer. 2. Insert the DVD in your computer. 3. Follow the instructions in the setup program. When setup is finished, disconnect your device from your computer or insert the memory card into your device. 4. Switch on your GPS receiver. 5. Launch TomTom NAVIGATOR by tapping or selecting the TomTom button in your device menu. You have to answer a few questions to set up TomTom NAVIGATOR. Answer the questions by tapping the screen or by using the joystick. Note: TomTom GPS receivers connect automatically when you start TomTom NAVIGATOR. If you are using a different GPS receiver, refer to the receiver's user manual for instructions. Tap or select buttons On devices with a touchscreen you tap buttons. On devices without a touchscreen you select buttons. This user guide always refers to tapping buttons. On mobile phones, many buttons are numbered. You can select those buttons using the number keys on your phone. Activation You will be asked how you want to activate the map that comes with NAVIGATOR. There are two ways to do this: • Automatically To activate automatically, your device must have an active wireless data connection (GPRS, EDGE, UMTS or CDMA). 4