Palsonic DVD2040 Owners Manual - Page 15

Trouble Shooting When there is a problem it does not mean malfunction, before sending the product for repair, please check your device according to the following. Please note that under no circumstances should you attempt to repair the system yourself; this will invalidate the warranty. Symptom No Power Remedy Make sure power cord is properly connected Check if there is power at the AC outlet by plugging in another appliance. No picture Check if the TV is switched on Check the video connection Check the appropriate video input mode on the TV, whether it receives another DV signal Unable to start playback Picture poor No sound The remote control does no work properly Wired Microphone unable to produce voice Player does not respond to some operating commands Player can not close the tray Player cannot open the tray If no disc is inserted, please insert the disc. Insert a playable disc of a correct type, check if regional code matches the DVD player. Ensure that the disc label is facing up. Clean the disc. Check if the disc is defective by trying another disc. Check to see if the disc is defective, badly scratched or warped (not flat). Clean the disc if there are finger prints or dirt with a soft cloth, wiping from the centre to the edge in a straight line. Check the audio connection. Select the correct input mode of the audio receiver. Point the remote control at the remote sensor of the DVD player. Operate the remote control within about 23 ft (7m) Inspect or replace the batteries. Adjust the microphone volume to suitable volume. Turn on the microphone. Operations may not be permitted by the disc Please place the disc again on the centre of the tray. If the tray is locked by obstacle or disc, please use the thin stick to enter into Emergency Opening Hole and move the inside bar on the bottom of the player manually. 14