Palsonic DVD3000 Owners Manual - Page 23

Troubleshooting Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. Symptom(Common) No power Play fails to start even when " " (confirm /play) is pressed. Play commences but then stops immediately. No picture. No sound. Distorted sound. Picture is distorted during rapid advance or rapid reverse. No fast forward (or fast reverse) play. No 4:3 (16: 9) picture. No operations can be performed with the remote control. No key operation ( by the unit and/ or the remote control ) is effective. Remedy Insert the power plug securely into the power outlet. Condensation has formed: wait about 1 or 2 hours to allow the player to dry out. This player cannot play discs other than DVDs, VCDs and audio CDs. The disc may be dirty and require cleaning. Ensure that the disc is installed with the label side up. Ensure that the equipment is connected properly. Ensure that the TV input setting is "AV" Ensure that the equipment is connected properly. Ensure that the input setting for the TV and stereo system are proper. No sound is heard during still ( pause) or picture slowmotion play. The picture will be somewhat distorted at times: this is normal. Some discs may have sections which prohibit fast forward (or fast reverse). Choose the correct setup "TV SCREEN" item which matches the TV set used. Check the batteries are installed with the correct polarities(+) or ( - ) The batteries are depleted: replace them with new ones. Point the remote control unit at the remote control sensor and operate. Operate the remote control unit at a distance of not more than 7 meters from the remote control sensor. Remove the obstacles between the remote control unit and remote control sensor. Turn the unit off and then back to on. Alternatively, turn off the unit, disconnect the AC power cord and then re-connect it. (The player may not be operating properly due to lighting, static electricity or some other external factor.) Symptom[DVD] Remedy Audio soundtrack and/or subtitle language is not the one selected at the initial settings Some function fails to operate while pressing the corresponding keys. If the audio soundtrack and/or subtitle language does not exist on the disc,the language selected at the settings will not be seen/heard. Due to the reason of discs, the DVD player may function with a little differences. This may not be regarded as the malfunction of the player. 21