Palsonic pal50bfz Owners Manual - Page 3

Instructions for Use, petrol, then load

Page 3 highlights

petrol, LP gas and glue etc in the refrigerator. 3. Don't splash water on the refrigerator; it may cause malfunction or electric shock. 4. If gas leaks from its container. Do not pull the plug out or in as it may arose sparks and fire calamities. Instructions for Use 1. When operating the refrigerator for the first time, run it without loading any food until its auto tops at the desired temperature. Usually it takes 2 or 3hours, then set the thermostatic dial at the setting desired and then load the refrigerator. 2. The temperature of the refrigerator can be adjusted by turning the thermostatic dial. A medium setting of the thermostatic dial is the most suitable for general operation. 3. Defrost the freezing compartment whenever the layer of frost on the surface of the evaporator reaches 3 or 4 mm. When defrosting, remove all food and set the thermostat at "OFF" position. Put the drip tray under the evaporator to collect melted water. After the frost has melted, discard the melted water and dry up the interior of refrigerator. The refrigerator can then be restarted by turning its thermostat to the desired setting. 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9

petrol
, LP gas and glue etc in the refrigerator.
3. Don’t splash water on the refrigerator; it may
cause malfunction or electric shock.
4. If gas leaks from its container. Do not pull the
plug out or in as it may arose sparks and fire
calamities.
Instructions for Use
1. When operating the refrigerator for the first time,
run it without loading any food until it
s
auto
tops at the desired temperature. Usually it takes
2 or 3hours, then set the thermostatic dial at the
setting desired and
then load
the refrigerator.
2. The temperature of the refrigerator can be
adjusted by turning the thermostatic dial. A
medium setting of the thermostatic dial is the
most suitable for general operation.
3. Defrost the freezing compartment whenever the
layer of frost on the surface of the evaporator
reaches 3 or 4 mm. When defrosting, remove all
food and set the thermostat at “OFF” position.
Put the drip tray under the evaporator to collect
melted water. After the frost has melted, discard
the melted water and dry up the interior of
refrigerator.
The
refrigerator
can
then
be
restarted by turning its thermostat to the desired
setting.
2