Panamax MB1500 Manual - Page 4

MB1500/F1000-UPS FRONT PANEL INSTALLATION The MB1500 is shipped with the front panel unattached to ensure that no damage is caused during shipping. Before the MB1500 can be used, the front panel must be installed. A. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE." B. CAUTION: When replacing batteries, replace with the same type of the original batteries C. CAUTION: Before replacing batteries, remove conductive jewelry such as chains, wrist watches, and rings. High energy through conductive materials could cause severe burns; D. CAUTION: Do not dispose of batteries in a fire. The batteries may explode. E. CAUTION: Do not open or mutilate batteries. Released material is harmful to the skin and eyes. It may be toxic. 1. Remove front panel from shipping inserts (pic, CP to provide) 2. Verify that the battery connectors are connected, red-to-red, black-to-black. If not connected, perform steps 2 and 6 in the BATTERY REPLACEMENT section. 3. (Optional) Install the supplied rubber end-caps to the sides of the front panel. Push the curved edge of the end-cap into the mating slots of the front panel. MB1500/F1500-UPS BATTERY REPLACEMENT 4. Carefully align the front panel connector and latches with the MB1500. 5. Gradually apply pressure to the left and right ends of the front panel until you hear the latches 'click'. 1. Remove the front panel. Remove the rubber end caps and pull up on the latch mechanism. Once the latch mechanism stops, gradually pull the front panel off of the MB1500. 2. Remove the screw from the battery connector security plate to release the battery connector. 3. Disconnect both the red and black connectors. 4. Remove the screws from the battery pack (part number BC-1500) and pull the battery pack out of the unit using the integrated handle. 5. Install the new battery pack into the unit. DO NOT ATTEMPT TO REPLACE THE BATTERIES IN THE ORIGINAL BATTERY PACK. IMPROPER INSTALLATION CAN RESULT IN FIRE OR BATTERY LEAKAGE. 6. Reconnect the red and black connectors and reinstall the battery connector security plate. POWER BANKS 1 2 3 WIRING 4 FAULT MENU 7. Reinstall the front panel per the Front Panel Installation instructions. POWER BANKS 1 2 3 WIRING 4 FAULT MENU 2