Panamax MIW-POWER-PRO-PFP Manual - Page 1

MIW-POWER-PRO-PFP INSTALLATION INSTRUCTIONS CAUTION: Only for use with 15 Amp circuits utilizing a minimum of 14 AWG. Make sure the circuit is not live before installation. If you are unsure how to perform this task, please contact an electrician. STEP 1: Select a location close to the equipment. In the case of a flat panel display, the recommended location is one that is behind the device and hidden from view once the Plasma TV is mounted. Cut a 4" wide by 3 3/4" high hole in the wall for the outlet box. STEP 2: Run the building wire (e.g. Romex) through a rear opening in the outlet box (not included). No more than 1" of wire sheath should extend into the outlet box. 3" of wire should be able to extend beyond the opening of the outlet box. Install the outlet box in the hole. (Outlet boxes not included) STEP 3: Strip building wire. Using the included wire nuts, first connect the ground wires - green insulated on the MlW-Power-Pro-PFP and bare copper on the building wire. Then connect the neutral wires (white), then the hot wires (black). STEP 4: Neatly fold the AC wires as you install the MIW-Power-Pro-PFP in the outlet box and secure with the included screws. STEP 5: Turn the power on to the circuit. The blue Power indicator should light up, indicating the outlet is ready for use. NOTES: In the event of a hazardous voltage situation, the red Unsafe Voltage indicator will light up until the voltage returns to a safe level. Signal Protection Module Usage: Panamax In-Wall signal protection modules (sold separately), while not necessary for surge protection in the Max In-Wall Power-Pro-PFP, may be used to provide a clean looking interface for the signal lines. When used in the proper manner the modules also provide total protection to the connected equipment. INS00840 REV E 02/10 1