Panamax MIW-XT Manual - Page 2

NOTE: DO NOT PRINT RED LINES. DASHED LINES SHOW FOLD PLACEMENT. MIW-XT INSTALLATION INSTRUCTIONS fig. 1 MIW-XT With Keystone insert fig. 2 MIW-XT With Decora® adapter PASS THROUGH CONFIGURATION New work installation using signal bay and Carlon SC200DV plastic electrical box. fig. 3 Mounting Bracket with fig. 4 Mounting Bracket keystone module insert option and wall cut-out Retaining Clip IEC Cord fig. 5 Mounting Bracket installed, rear view showing mounting ears fig. 6 Rear of MIW-XT showing wire pigtails Rubber Grommet MIW Pass-Through Insert Faceplate Low-voltage signal bay Mounting Bracket Electrical box (not included) fig. 7 MIW PassThrough Insert Rubber Grommet MIW Pass-Through Insert fig. 8 Panamax Max In-Wall Signal Line Protection Module Installation requires use of an outlet box or boxes that are NOT provided with the product. Product has been tested thoroughly to be compatible with the following outlet boxes: Plastic: Metal: NEW WORK Carlon SC200DV Raco 8355 OLD WORK Carlon B114R Raco 508 (hardware removed) DECORA CONFIGURATION Installation using Decora adapter and Carlon B114R electrical box. Electrical box (not included) Decora® Decora® 6-port trim plate insert adapter (not included) Mounting Bracket Electrical box (not included) Faceplate #6-32 countersunk screw (not included) Mounting Bracket Faceplate Decora® Decora® 6-port trim plate insert adapter (not included) Retaining Clip IEC Cord KEYSTONE CONFIGURATION Installation using Keystone insert and Raco 508 (or 8500) electrical box. #6-20 screw Mounting Post Mounting Ear Electrical box (not included) #2.6-28 screw Faceplate Keystone Module #6-20 Insert screw Mounting Mounting Electrical box (not Post Ear included) #2.6-28 screw Faceplate Low-voltage signal bay Keystone MIW Pass- Mounting Module Through Bracket Insert Insert Retaining Clip IEC Cord MIW Pass- Mounting Through Insert Bracket Low-voltage signal bay INSTALLATION ALERT INSTALLATION ALERT