Panasonic 3-MOS P2 Hand-held Camcorder Basic Operating Instructions - Page 21
Power sources, Using the battery, Using the AC adaptor, Installation, Removal
View all Panasonic 3-MOS P2 Hand-held Camcorder manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Power sources Using the battery Installation Insert the battery until it clicks into place. Removal 1 Set the POWER/MODE switch to OFF, and check that the mode lamp is off. (Page 25) 2 While pressing the battery release button, raise up the battery to remove it. • Support the battery with your hand to ensure that it will not fall. Preparation Mode lamps Battery release button Using the AC adaptor Installation 1 Insert the DC cable's battery connector until it clicks into place. 2 Connect the AC power supply cable. Connect the AC power supply cable in the order 1 and 2. DC cable's battery connector Insert it all the way in. 1 2 Removal 1 Set the POWER/MODE switch to OFF, and check that the mode lamp is off. (Page 25) 2 Remove the DC cable's battery connector while pressing the battery release button. 3 Disconnect the AC power supply cord from the power outlet. • Disconnect the AC power supply cable from the power outlet when the unit is not going to be used. • When the AC power supply cable is disconnected from the power outlet, the power lamp on the AC adaptor remains lit for a while then shuts off. This is not a malfunction. 21