Panasonic AG-AC130A Operating Instructions Advanced - Page 34
Adjusting the shutter speed, Using the <SHTR> dial, Setting the shutter
View all Panasonic AG-AC130A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Adjusting the shutter speed Using the dial button dial 1 Press the button. ••The role of the dial changes in the following order. [DIAL SHUTTER][DIAL SYNCHRO SCAN][DIAL LOCK] ••To select [DIAL SYNCHRO SCAN], press the button and select [DIAL SHUTTER], and turn the dial to set the synchro scan. • After approximately 12 seconds without a dial operation, [DIAL LOCK] will be set automatically. To operate the camera again, press the button. The camera resumes the last operated mode. You can also use the button to set [DIAL LOCK] in order to prevent unintentional operation. Setting the shutter 1 Press the button and select [DIAL SHUTTER]. 2 Press the dial. ••Each time the dial is pressed, the shutter will turn ON/OFF. ••The shutter speed is changed in the order shown in the charts on page 35 by turning the dial when the shutter is ON. • Remember that the faster the shutter speed, the lower the camera sensitivity. • Focusing on the subject would take longer if the shutter speed is reduced, it is therefore recommended that the camera be secured to a tripod, etc. during shooting. • Under the lighting of electric discharge tubes such as fluorescent lamps, horizontal bands may appear on the screen. Adjusting the shutter speed may improve this condition. • A subject that quickly crosses the camera may appear distorted when shot. This is due to the signal reading system of the pickup devices (MOS sensor), and is not a defect. • At slow shutter speeds (1/6 to 1/15), white, red, green, or blue dots may appear on the screen, however, this is not a defect. 34