Panasonic AGVP300 AGVP300 User Guide - Page 54

Error Messages Before requesting service, check the following points once again. On Screen Display ª VCR PLEASE PUT IN A VIDEO CASSETTE. ≥[REC¥] (¥REC/OTR) or [TIMER ] ( TIMER REC) has been pressed without a video cassette inserted. Insert a video cassette with an intact erasure prevention tab. PLEASE STOP THE TAPE. ≥CHANNEL SET has been selected during playback. Stop the tape. PLEASE SET THE CLOCK. ≥[TIMER ] ( TIMER REC) or [PROG/CHECK] has been pressed when the clock is not set. Set the clock. PLEASE USE A CASSETTE WITH TAB. ≥[REC¥] (¥REC/OTR) or [TIMER ] ( TIMER REC) has been pressed without a video cassette with an intact erasure prevention tab. Use a video cassette with an intact erasure prevention tab. NO TIMER RECORDING HAS BEEN SET. ≥[TIMER ] ( TIMER REC) has been pressed with no timer programs. Set timer recording. ª DVD Cannot display group xx, picture xx ≥You are trying to display incompatible pictures. The progressive out is set ≥Go to "Video" in the SET UP menus, and select "Enable" in "Progressive Out (Component)". to "Disable" 20, 22 29 28 5 22 - 49 Self-diagnostic Indications This unit has a self-diagnosis and display function. If this unit detects trouble during installation or during use, the following indications automatically appear in the unit's display. Indications are in the form of a single English letter plus two numbers, such as [H01]. ª VCR H∑∑, F∑∑ ≥An error has occurred. The number following "H" or "F" depends on the status of the unit. - (∑∑ stands for a number.) Reset procedure: Press [POWERÍ/I] to switch the unit to the standby mode and then back to ON. Alternatively, press [POWERÍ/I] to switch the unit to the standby mode, disconnect the AC power supply cord, and then reconnect it. ≥If the service numbers fail to clear, note the service number and contact a qualified service - person. ª DVD U11 ≥Disc is dirty. Wipe it clean. 6 H∑∑, F∑∑ ≥An error has occurred. The number following "H" or "F" depends on the status of the unit. - (∑∑ stands for a number.) Reset procedure: Press [POWERÍ/I] to switch the unit to the standby mode and then back to ON. Alternatively, press [POWERÍ/I] to switch the unit to the standby mode, disconnect the AC power supply cord, and then reconnect it. ≥If the service numbers fail to clear, note the service number and contact a qualified service person. No DISC ≥You haven't inserted a disc; insert one. - ≥You haven't inserted the disc correctly; insert it correctly. 32 No PLAY ≥You inserted a disc the unit cannot play. 6 ≥You inserted a blank DVD-RAM. - ≥A disc whose playback is restricted in the SET UP menus, "Disc"l"Ratings", is inserted. Change the "Ratings" setting. 49 ERROR ≥Incorrect operation performed. Read the instructions and try again. - 54