Panasonic AJD610WAP AJD610WA User Guide - Page 73
When the White Balance Cannot be Automatically Adjusted, Error messages related to white balance
View all Panasonic AJD610WAP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Adjusting the White Balance/Black Balance When the White Balance Cannot be Automatically Adjusted An error message will appear on the viewfinder screen. (The message appears when the display mode is set to "2" or "3".) The displayed messages are as follows. Error messages related to white balance adjustment Error message COLOR TEMP. HIGH COLOR TEMP. LOW LOW LIGHT LEVEL OVER UNSTABLE CONDITION Meaning The color temperature is too high. The color temperature is too low. There is insufficient illumination. There is too much illumination. The shooting conditions are unstable (shooting is taking place under fluorescent lighting or the camera is not being held or pointed properly, etc.). Treatment Select an appropriate filter Select an appropriate filter. Increase the illumination or gain. Decrease the illumination or gain. If flickering is a problem, turn the SHUTTER switch to ON and stabilize the shooting conditions. If the above error messages appear, carry out the respective treatment attempt to adjust the white balance again. If the error message continues to appear even after repeated attempts, consult your dealer. |Notes{ ¡The white balance will not be adjusted while the setting menu is displayed on the viewfinder screen. The MENU SET/OFF switch must be set to the OFF position to make this adjustment. ¡In rare instances the white balance adjustment may not be possible and an NG display will appear. In a case like this, proceed with the white balance adjustment again. When there is no Time to Adjust the White Balance Set the WHITE BAL switch to PRST. The white balance for the filter is automatically adjusted according to the setting position of the FILTER knob (outside). White balance memories The white balance memories fall into two categories, A and B. The number of A and B memories is limited to 1 each when FILTER INH is set to ON (default setting) on the "CAMERA SW MODE" SUB menu page of MAIN menu screen 2 of 4. In this case, the contents of the memories are not linked to the filter. However, when FILTER INH is set to OFF, the adjustments values for each filter can be automatically stored in the memory corresponding to the WHITE BAL switch setting (A or B). The unit contains 4 filters, making a total of 8 (4q2) adjustment values which can be stored. - 73 -