Panasonic AJSD755P AJSD755 User Guide - Page 13
REAR PANEL, DIGITAL AUDIO IN and OUT connectors
View all Panasonic AJSD755P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Parts and their functions Rear panel 1 AC IN SIGNAL GND 2 3 4 5 6 7 8 9: ; AES/EBU CH1/2 IN CH1/2 OUT Y PB ANALOG VIDEO IN ON Y 75Ω OFF PB REF VIDEO IN ON PR 75Ω OFF 1 VIDEO OUT 2 (WFM) REMOTE REMOTE IN/OUT REMOTE OUT ENCODER REMOTE RS-232C PARALLEL PR 3 (SUPER) ANALOG CH1 PUSH AUDIO PUSH CH2 IN PUSH TC IN TC OUT OPTION 1 SDI IN OUT 1 ACTIVE THROUGH 2 CH1 AUDIO CH2 MON OUT L 3 (SUPER) OPTION 2 SDTI IN OUT MON R 1 2 SERVICE ONLY 1 AC IN socket Connect one end of the power cord supplied to this socket and the other end to the power outlet. 2 DIGITAL AUDIO IN and OUT connectors These are the input and output connectors for digital audio signals that comply with the AES/EBU standards. The digital audio signals which are to be input to these connectors must be synchronized with the video input signals. Otherwise, noise will be generated in the audio output signals. 3 ANALOG COMPONENT VIDEO IN connectors The analog component video signals are input to these connectors. 4ANALOG COMPOSITE VIDEO IN connectors and 75 Ω termination switch The analog composite video signals are input to these connectors. A loop-through configuration is featured for each pair of input connectors. For termination at this VTR, set the termination switch to ON. 5 REF VIDEO IN connectors and 75 Ω termination switch These are the input connectors of the reference video signals. Input a reference signal with color burst. For termination at this VTR, set the termination switch to ON. Video and audio output may be disturbed when the reference video signal is not input, so it is recommended that a system which inputs the reference video signal be used. 6 Remote control connectors These connectors make it possible to use two of these VTRs or to connect this VTR to an external controller so that the VTR can be operated from an external component. Two remote control connectors are provided: one for IN/OUT use and the other for OUT use only. IN/OUT: For connection with an external controller For connection with deck-to-deck operations OUT: For connection with parallel run operations For loop-through use If connection is to be made to the OUT connector for deck-to-deck operations where this VTR will serve as the recorder, which of the two connectors is to be used can be selected using setup menu No. 212 (MASTER PORT). 7 ENCODER REMOTE connector An external encoder remote controller is connected to this connector when the video output signal settings are to be adjusted from an external component. 8 ANALOG AUDIO IN connectors These are the analog audio input connectors. 9 TIME CODE IN connector This connector is used to record an external time code onto the tape. : TIME CODE OUT connector During playback, the playback time code is output through this connector. During recording, the time code generated by the internal time code generator is output. ; SDI input and output connectors (optional) At these connectors, it is possible to input and output digital component audio and video signals which comply with the SMPTE 259M-C standard by installing the SDI board (AJ-YA755G, available as an optional accessory) in the VTR. Video signals containing superimposed information can be output through the SDI OUT 3 connector. Whether the superimposing is to be set ON or OFF is selected using the SUPER switch W on the front panel. The digital audio signals which are to be input to these connectors must be synchronized with the video input signals. Otherwise, noise will be generated in the audio output signals. 13