Panasonic BB-HCM515A Installation Guide - Page 2
Connections - manual
UPC - 037988845163
View all Panasonic BB-HCM515A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Connections Before proceeding, confirm that your PC is connected to your router and can access the Internet. Also confirm that your router's UPnP™ feature is enabled. (Most routers have UPnP™ turned off by default.) Refer to the operating instructions included with your router or to the Panasonic Network Camera website (http://panasonic.co.jp/pcc/products/en/netwkcam/) for more information. When connecting the camera using PoE (Power over Ethernet) Connect the camera to your PoE hub using a LAN cable (Cat-5 straight cable) as described below. 1 Connect a LAN cable to the camera and to the PoE hub. • Your PoE hub must be connected to the router. Refer to the operating instructions included with the PoE hub for connection instructions • The lens will pan and tilt when the camera is turned on. 2 Connect a LAN cable to a LAN port of the PoE hub and to a LAN port of the router. • Confirm that the indicator lights green after about 1 minute. If the indicator does not light green, see 1.2 Camera Indicator Issues in the Troubleshooting Guide on the CD-ROM. PoE indicator LINK indicator LAN cable (Cat-5 straight cable) PoE hub To the power supply Green • When the lens pans or tilts, a sound can be heard from the camera. This is normal. • Use a 4-pair UTP/STP cable. • Do not use a relay connector or a hub between the camera and the PoE hub. These devices may disturb the data or electricity transmission. • If the PoE hub has indicators, the indicator lights as shown in the table below. Indicator Description LINK Turns on when the data is transmitted from the camera. PoE Turns on when the electricity is supplied to the camera. • If the PoE hub is turned off or power supply is temporarily cut off by the disconnection of the LAN cable, it may take time for the PoE hub's indicators to light green. • The indicator display differs depending on manufacturers, refer to the manuals of the PoE hub. Router Internet Modem PC When connecting the camera using the BB-HCA3A AC Adaptor (Optional) Connect the camera to your router and to the power outlet as described below. 1 Connect the LAN cable to the camera and the router. 2 Connect the AC adaptor cord to the DC IN jack. 3 Connect the AC cord to the AC adaptor, then plug the AC cord into the power outlet. • The lens will pan and tilt when the camera is turned on. • Confirm that the indicator lights green after about 1 minute. If the indicator does not light green, see 1.2 Camera Indicator Issues in the Troubleshooting Guide on the CD-ROM. To the power outlet LAN cable (Cat-5 straight cable) Router AC cord Green • When you operate the camera, the power outlet should be near the camera and easily accessible. • Use only specified Panasonic AC adaptor (Model No. BB-HCA3A). • When the lens pans or tilts, a sound can be heard from the camera. This is normal. AC adaptor (BB-HCA3A) Internet Modem PC After the camera's indicator turns green, you may set up the camera. Continue by following the procedure described in the included Setup Guide. • If the indicator does not turn green, see 1.2 Camera Indicator Issues in the Troubleshooting Guide on the included CD-ROM. 2