Panasonic BL-C160 User Guide - Page 1

Important Information Network Camera Outdoor Ready BL-C140 Model No. BL-C160 Please read this document before using the product, and save this document for future reference. Panasonic Network Camera Website: http://panasonic.net/pcc/ipcam/ How to Use the Documentation This manual is written for both the BL-C140 and BL-C160. Available features and operations vary slightly depending on the model. You can confirm the model no. of your camera by checking the model no. printed on the front of the camera. Model number suffixes ("CE" and "E") are omitted from the following model numbers shown in this document, unless necessary. BL-C140CE, BLC140E, BL-C160CE, BL-C160E. All documentation can be found on the included CD-ROM. • Important Information (PDF format; printed version also included) This document. Provides general information and safety instructions for using the camera. • Installation Guide (PDF format; printed version also included) Describes how to physically connect the camera to the power supply and network, as well how to mount or place the camera for regular use. • Setup Guide (PDF format; printed version also included) Describes how to set up the camera so that it can be accessed using a PC. • Operating Instructions (HTML format) Explains how to operate, program, and maintain the camera. • Troubleshooting Guide (HTML format) Provides solutions for problems you may have when using the camera. Abbreviations • The Network Camera is referred to as "the camera" in this document. • The Setup CD-ROM is referred to as "the CD-ROM" in this document. IMPORTANT SAFETY INSTRUCTIONS When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 1. Read and understand all instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Attach the Safety Wire to the camera to prevent it from dropping. 6. After taking away the sand or the dust on the lens cover, wipe the lens cover with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat. 9. Protect the AC adaptor cord and the AC cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the unit. 10. The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily accessible. 11. Only use attachments/accessories such as stand specified by the manufacturer. 12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptor cord, or the AC cord during lightning storms. 13. Unplug the unit from power supply when unused for long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the unit has been damaged in any way, such as when the AC adaptor, the AC adaptor cord, or the AC cord is damaged, the unit does not operate normally, or has been dropped. 15. Prolonged exposure to direct sunlight or halogen light may damage the image sensor. 16. Keep the sensor-range caps out of reach of children to prevent swallowing. 17. Unplug this unit from power outlets if it emits smoke, an abnormal smell or makes unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorized service center. 18. The camera features a splash-resistant body, but it is not waterproof. 19. The AC adaptor, the AC adaptor cord, the AC cord, and the power transfer unit are not splash resistant, and are intended for indoor use only. 20. When connecting the cable, waterproof the cable using the included right-angle joint, foam strip and self bonding tape. © Panasonic System Networks Co., Ltd. 2008 PQQX16446XA KK0508CM2120 (CE) 21. When installing cables through the ground, do not connect cables under the ground. Install cables through a conduit to protect them from water. 22. For BL-C160 CAUTION: The camera of this unit utilizes LED lights. Do not look directly at the LED lights for long periods of time, as this can cause weakened eyesight. SAVE THESE INSTRUCTIONS Other Information Environment: Do not install the camera where the temperature is less than -20 °C or greater than +50 °C. Allow 10 cm clearance around the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight. Routine care: Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder. When you leave the unit unused for a long period of time, disconnect the plug of the AC cord from the outlet. If you have any problems: Consult an authorized service center. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. No responsibility will be taken by our company with respect to consequences resulting from the use, damage or both of the camera. System Requirements Your PC and network must meet the following technical specifications in order for the camera to function properly. Item Operating System CPU Display Protocol Requirement For IPv4 Connection Microsoft® Windows Vista®, Windows® XP, Windows 2000 For IPv6 Connection*1 Microsoft Windows Vista, Windows XP Service Pack 1 or later 2.0 GHz Celeron® or faster 1024 x 768 resolution or higher For IPv4 Connection TCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ARP, ICMP) For IPv6 Connection TCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ICMPv6, NDP) Interface Web Browser 10/100 Mbps network card Internet Explorer® 6.0 or later (not included) Additional Software (For Viewing Buff- ered MPEG-4 Images) For Windows Vista Windows Media® Player 11 or later For Windows XP Windows Media Player 9 or later For Windows 2000 Windows Media Player 9 *1 What is IPv6? • IPv6 is short for "Internet Protocol Version 6". • IPv6 was created to provide the additional IP addresses that will be needed as the Internet continues to expand. • IPv6 is expected to gradually replace IPv4, with the 2 coexisting for a number of years during a transition period. • Though most ISPs (Internet Service Providers) do not yet support IPv6, many local networks already use it. When your ISP supports IPv6, your Panasonic Network Camera will be ready! Note: Refer to the Panasonic Network Camera website at http://panasonic.net/pcc/support/netwkcam/ for details about network environment.