Panasonic CF-T8EWETZ2M Operating Instructions - Page 12

Getting Started First-time Operation 3 3 Connect your computer to a power outlet. The battery charging starts automatically. CAUTION Do not disconnect the AC adaptor and do not switch the wireless switch to on until the first-time operation procedure is completed. When using the computer for the first time, do not connect any peripheral device except the battery pack and AC adaptor. Handling the AC adaptor • Problems such as sudden voltage drops may arise during periods of thunder and lightning. Since this could adversely affect your computer, an uninterruptible power source (UPS) is highly recommended unless running from the battery pack alone. 4 4 Turn on the computer. Slide and hold the power switch power indicator lights. for approximately one second until the CAUTION Do not slide the power switch repeatedly. The computer will forcibly be turned off if you slide and hold the power switch for four seconds or longer. Once you turn off the computer, wait for ten seconds or more before you turn on the computer again. Do not perform the following operation until the hard disk drive indicator turns off. • Connecting or disconnecting the AC adaptor • Sliding the power switch • Touching the keyboard, touch pad or touchscreen • Closing the display Do not change the Setup Utility until completing step 5. If you do so, Windows setup may not operate properly. 5 Setup Windows. Follow the on-screen instructions. The computer will restart after the setup is complete. To go to the next step, wait until the hard disk drive indicator off. has turned CAUTION Do not turn off the computer until completing the first-time operation procedure. When you set date/time/time zone and click [Next], the screen may not go to the next step for a few minutes. Do not touch the keyboard, touch pad or touchscreen, and wait until the screen changes. When using the included stylus, avoid touching the screen with you hands, etc. This can cause input errors. The keyboard will operate as the US keyboard until the keyboard setting is changed. Because of this, some alphabets shown on display may differ from inputted ones. To avoid the accidental selections, during setting up Windows, • Use the touch pad to make some selections. • Press the NumLock key and input in the Ten-key mode to input numbers. To match the languages, change the language settings after setting up Windows ( page 13). Do not change the settings in [To change system or these settings, click Customize] of [Regional and Language Options] during setting up Win- dows. 12