Panasonic CQC3200U Auto Radio/cd Deck - Page 21

Electrical Connections

Page 21 highlights

E N G Electrical Connections L I S H Caution: 33 ≥ This product is designed to operate with a 12 V DC, negative ground battery system. ≥ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. ≥ To prevent damage to the unit, be sure to follow Bundle all cables and keep cable terminals free the connection diagram below. from touching any metal parts. ≥ Remove approximately 1/4q (5 mm) of protective ≥ Remember, if your car has a drive computer or covering from the ends of the leads before a navigation computer, the data of its memory connecting. may be erased when the battery terminals are ≥ Do not insert the power connector into the unit disconnected. until the wiring is completed. Wiring Diagram Accessory used for wiring No. Item Q'ty 6 Power connector 1 External amplifier control power lead (max. 500 mA) This lead is for connection to the power amplifier. Note: ≥ This lead is used for power control when an external power amplifier is connected. The power supply of a power amplifier will be activated when turning on the power of this unit. Antenna (Blue/white stripe) Dual CD changer control lead Note: ≥ Insulate this lead with vinyl tape when you do not connect it. Antenna control lead (to motor antenna) (max. 500 mA) This lead is not intended for use with switch actuated power antenna. Note: ≥ The power antenna extends automatically when the AM/FM radio mode is selected. ACC power lead To ACC power, i12 V DC. Battery lead To the car battery, continuous i12 V DC. Ground lead To a clean, bare metallic part of the car chassis. 52 CQ-C3400/3300/3200/3100U (Brown/white stripe) (Blue) ACC BATTERY 15 A (Red) (Yellow) (Black) CQ-C3400U CQ-C3300U CQ-C3200U CQ-C3100U CD changer control connector E N G L I S CQ-C3400U CQ-C3200U Monaural H Subwoofer cord (red) 34 S.W-OUT (white) CD changer input cord CD.C-IN R (red) L (white) Pre-amp output connector (rear) Pre-amp output connector (front) L (white) R (red) 6 Power connector Fuse (mini auto fuse type, 15 A) ≥ If the fuse (rear panel) blows frequently, they may be something wrong with the unit or wiring connection. Consult your nearest Panasonic Servicenter for service. Front speaker lead FRONT SP Rear speaker lead REAR SP L R (White) + (White/black stripe) + (Gray) - (Gray/black stripe) (Green) + (Green/black stripe) + (Violet) - (Violet/black stripe) Left To front speaker Right Left To rear speaker Right Caution: ≥ Do not connect more than one speaker to one set of speaker leads. CQ-C3400/3300/3200/3100U 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

52
CQ-C3400/3300/3200/3100U
CQ-C3400/3300/3200/3100U
53
+
-
+
-
+
-
+
-
FRONT SP
REAR SP
ACC
BATTERY 15 A
CD.C-IN
S.W-OUT
L
R
CQ-C3400U
CQ-C3300U
CQ-C3200U
CQ-C3100U
CQ-C3400U
CQ-C3200U
Electrical Connections
Caution:
This product is designed to operate with a 12 V
DC, negative ground battery system.
To prevent damage to the unit, be sure to follow
the connection diagram below.
Remove approximately
1
/
4
q
(5 mm) of protective
covering from the ends of the leads before
connecting.
Do not insert the power connector into the unit
until the wiring is completed.
Be sure to insulate any exposed wires from
a possible short-circuit from the car chassis.
Bundle all cables and keep cable terminals free
from touching any metal parts.
Remember, if your car has a drive computer or
a navigation computer, the data of its memory
may be erased when the battery terminals are
disconnected.
Accessory used for wiring
Wiring Diagram
No.
Item
Q’ty
6
Power connector
1
External amplifier control power lead
(max. 500 mA)
This lead is for connection to the power amplifier.
Note:
This lead is used for power control when an external
power amplifier is connected. The power supply of a
power amplifier will be activated when turning on the
power of this unit.
Dual CD changer control lead
Antenna control lead
(to motor antenna) (max. 500 mA)
This lead is not intended for use with switch actuated
power antenna.
ACC power lead
To ACC power,
i
12 V DC.
Battery lead
To the car battery, continuous
i
12 V DC.
Ground lead
To a clean, bare metallic part of the car chassis.
Note:
Insulate this lead with vinyl tape when you do not
connect it.
Note:
The power antenna extends automatically
when the
AM/FM radio mode is selected
.
Antenna
(Blue/white stripe)
(Brown/white stripe)
(Blue)
(Red)
(Yellow)
(Black)
CD changer control
connector
Subwoofer cord
CD changer input cord
Monaural
(red)
(white)
R (red)
L (white)
6
Power connector
Fuse (mini auto fuse type, 15 A)
If the fuse (rear panel) blows frequently, they may be
something wrong with the unit or wiring connection.
Consult your nearest Panasonic Servicenter for service.
Front speaker lead
Rear speaker lead
(White)
(White/black stripe)
(Gray)
(Gray/black stripe)
Left
To front
speaker
Right
Caution:
Do not connect more than
one speaker to one set of
speaker leads.
E
N
G
L
I
S
H
33
E
N
G
L
I
S
H
34
Left
To rear
speaker
Right
(Green)
(Green/black stripe)
(Violet)
(Violet/black stripe)
Pre-amp output
connector (rear)
Pre-amp output
connector (front)
L (white)
R (red)