Panasonic DMPBDT210 DMPBDT110 User Guide - Page 37
Messages, On the television, On the unit's display
UPC - 885170033481
View all Panasonic DMPBDT210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Messages The following messages or service numbers appear on the television or unit's display when something unusual is detected during startup and use. On the television Cannot play. ¾ You inserted an incompatible disc (Discs recorded in PAL video, etc.). Cannot display on this unit. ¾ You tried to play a non-compatible image. ¾ Confirm "SD" on the unit's display is not displayed and re-insert the card. No disc is inserted. ¾ The disc may be upside down. $ This operation is not available. ¾ Some operations are unsupported by the unit. For example; - BD-Video: During playback, reverse slow-motion or reverse frame-by-frame is not possible. IP address is not set. ¾ The "IP Address" in "IP Address/DNS Settings" is Set the "IP Address", "Subnet Mask", and "Default Gateway". (Select the automatic address acquisition if necessary.) The current settings only offer minimal wireless access point security and low performance. It is recommended to change it for better security. ¾ Authentication type for the Wireless LAN is set to "Open system", or the encryption type is set to "No encryption". It is recommended to encrypt for safety reasons. For details, refer to the instructions of the Wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices. On the unit's display F99 ¾ The unit fails to operate properly. Press [POWER Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on. HDMI ONLY ¾ Some BD-Video discs can only be output with HDMI. NET ¾ While connecting to a network. No PLAY ¾ There is a viewing restriction on a BD-Video or DVD-Video. (> 29) No READ ¾ The media is dirty or badly scratched. The unit cannot play. PLEASE WAIT ¾ The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while "PLEASE WAIT" is displayed. REMOVE ¾ The USB device is drawing too much power. Remove the USB device. SET (" " stands for a number.) ¾ The remote control and main unit are using different codes. Change the code on the remote control. Press and hold [OK] and the indicated number button at the same time for more than 5 seconds. U59 ¾ The unit is hot. The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Select a position with good ventilation when installing the unit. Do not block the ventilation hole on the side of the unit. U72 U73 ¾ The HDMI connection is not working properly. - Turn the unit and TV off. - Disconnect the HDMI cable between the player and the TV. H or F (" " stands for a number.) ¾ There is something unusual. ¾ Check the unit using the troubleshooting guide. If the service number does not disappear, do the following. 1 Disconnect the plug from the AC outlet, wait a few seconds, then reconnect it. 2 Press [POWER Í/I] to turn the power on. If the service number does not disappear despite doing the above, request service from the dealer. Inform the dealer of the service number when requesting service. START ¾ The system is being restarted during the firmware update. Please do not turn off the unit. UPD/ (" " stands for a number.) ¾ The firmware is being updated. Please do not turn off the unit. FINISH ¾ The firmware update is complete. Reference 37 VQT3B58