Panasonic DP-UB154K Owners Manual - Page 25

Reference Troubleshooting guide Before requesting service, please perform the following checks. Do you have the latest firmware installed? Panasonic is constantly improving the unit's firmware to ensure that our customers are enjoying the latest technology. ( 14) s Make the following checks and visit our website for more information. http://shop.panasonic.com/support s Or visit our website to find a service center. You can find a service center near you easily on our website. Other support information: "Limited Warranty" ( 33) The following do not indicate a problem with this unit: - Regular disc rotating sounds. - Image disturbance during search. - Image disturbance when replacing 3D discs. „ Unit does not respond to remote control or unit's buttons. Disconnect the AC adaptor, wait 1 minute, then reconnect the AC adaptor. „ Cannot eject disc. ① While the unit is on Press and hold [ ] on the main unit and the [0] on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash, and "00 RET" is displayed on the screen. ② Press [ ] (right) repeatedly on the remote control until "06 FTO" is displayed on the screen. ③ Press [OK]. General operation To return to the factory default. h Select "Yes" in "Restore Default Settings" in the Setup menu. ( 24) To return all settings to the factory preset. h Reset the unit as follows: ① While the unit is on Press and hold [ ] on the main unit and the [0] on the remote control at the same time for more than 5 seconds. - P OWER LED starts to flash, and "00 RET" is displayed on the screen. ② Press [ ] (right) repeatedly on the remote control until "08 FIN" is displayed on the screen. ③ Press and hold [OK] for more than 5 seconds. The remote control doesn't work properly. h Change the batteries in the remote control. ( 5) Other Panasonic products respond to this remote control. h Change the remote control code of other Panasonic products to other than code 1. The TV tuner mode is not displayed when the TV is turned on. h This phenomenon may occur, depending on the TV setting, when "Quick Start" is set to "On". h Depending on the TV, this phenomenon may be prevented by reconnecting the HDMI cable to a different HDMI input terminal or by changing the HDMI auto connection setting. This unit is turned off automatically. h To save on electricity, this unit is turned off automatically depending on the media if there is no button operation for about 20 minutes when not playing back (such as when paused or displaying the menu, displaying still pictures, etc.). - 25 -