Panasonic EP-MA70KX EP-MA70CX Owner's Manual (English) - Page 12

Setting up the massage lounger, Where to use the unit, Installing the unit

Page 12 highlights

English Setting up the massage lounger 1 Where to use the unit • Ensure adequate space to recline. • Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources, because this can cause discolouration or hardening of the synthetic leather. • Place the unit on a mat to prevent floor damage. • When placing a mat under the unit, the size of the mat should be sufficient [at least 47.2 in. × 27.6 in. (120 cm × 70 cm)] to cover the areas where the unit touches and where the legrest could touch the floor, as shown in the diagram on the right. • Install the unit near a power socket. See Warning No. 11 and 12 on page 1, and Caution No.23 on page 3. Keep at least 4" (10 cm) away from the wall. Approx. 79.6" (202 cm) Width approx. 37.4" (95 cm) Approx. 19.3" (49 cm) Approx. 11.8" (30 cm) 2 Installing the unit Hold onto the sides. Do not hold onto the front side. The sole massage section might slide, and injuries may occur. Hold onto the sides of the legrest. Place your fingers in the groove Legrest Back cover Mat Area where legrest Area where unit touches could touch the floor the floor Groove • Since the unit is very heavy [approximately 191.8 lbs (87 kg)], be careful to avoid back injuries. (The unit must be carried by two or more persons.) To put the unit down on the floor • Put the unit down slowly and carefully watch your step. • Put down the legrest by holding it with your hands until it has been set on the floor completely. If you release your hands before the legrest is fully extended, the legrest will forcefully return to the initial position. • The floor may get damaged, so it is recommended to place a mat etc. on the floor. See Caution No.22 and 23 on page 3. Mat 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

11
English
Setting up the massage lounger
1 Where to use the unit
• Ensure adequate space to recline.
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can cause
discolouration or hardening of the synthetic leather.
• Place the unit on a mat to prevent floor damage.
• When placing a mat under the unit, the size of the mat should be suffi
cient
[at least 47.2 in. × 27.6 in. (120 cm × 70 cm)] to cover the areas where the
unit touches and where the legrest could touch the floor, as shown in the
diagram on the right.
• Install the unit near a power socket.
See Warning No. 11 and 12 on page 1, and Caution No.23 on page 3.
Keep at least 4" (10 cm) away from the wall.
Approx. 79.6" (202 cm)
Width approx. 37.4" (95 cm)
Approx.
11.8"
(30 cm)
Approx. 19.3"
(49 cm)
Mat
Area where legrest
could touch the floor
Area where unit touches
the floor
2 Installing the unit
Groove
Hold onto the
sides of the
legrest.
Mat
Legrest
Back cover
Place your
fingers in the
groove
Do not hold onto
the front side.
The sole massage
section might slide,
and injuries may
occur.
Hold onto the sides.
• Since the unit is very heavy [approximately
191.8 lbs (87 kg)], be careful to avoid back
injuries. (The unit must be carried by two or
more persons.)
To put the unit down on the
floor
• Put the unit down slowly and carefully
watch your step.
• Put down the legrest by holding it with your
hands until it has been set on the floor
completely. If you release your hands before
the legrest is fully extended, the legrest will
forcefully return to the initial position.
• The floor may get damaged, so it is
recommended to place a mat etc. on the
floor.
See Caution No.22 and 23 on page 3.