Panasonic EW3153W Instruction Manual - Page 20
The cuff will loosen after the measurement, result has been shown for about 5 seconds.
View all Panasonic EW3153W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Taking a Reading (continued) Measurement 1 Press the On/Off and Start button on the main unit. (1) After the entire display on the wireless display has been lit, the pressure cuff will be tightened automatically. (2) Pressurization will be performed automatically and measurements will be taken. *It may take about 1 second for the wireless display to turn on after pressing the On/Off and the Start The entire display will light for approx. 1 second. button. This is not abnormal. *The angle of the main unit may change slightly while pressurizing. This will not affect accuracy. 2 When measurement has been completed, the blood pressure and pulse values will be displayed. The cuff will loosen after the measurement result has been shown for about 5 seconds. The pressure cuff will be tightened automatically. The heart mark will blink when pulse is detected during pressurization. 3 • The blood pressure indication ( mark) will flash for 6 seconds then stay lit. If the measurement is high, it will also flash for 6 seconds to indicate high blood pressure. (See page 22.) • The mark will light. (For storing measurement values, see page 24.) • The pulse rate value is the beats per minute calculated based on the pulse rate during measurement. • The mark is displayed when pulse rate could not be measured. Remove your arm from the main unit. 4 To switch off the blood pressure monitor, press the On/Off and Start button on the main unit. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 2 minutes. • When the Adjust button "2" on the wireless display is pressed, indications disappears but the power of the main unit is still on for about 2 minutes. 19 English