Panasonic EY7202 EY7202 User Guide - Page 6

23) Do not short the battery pack. A battery short can cause a large current flow, over heating and create the risk of fire or personal injury. 24) NOTE: If the supply cord of this appliance is damaged, it must only be replaced by a repair shop authorized by the manufacturer, because special purpose tools are required. 25) TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. IV. ASSEMBLY Attaching or removing bit NOTE: • When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). 1. Hold the collar of quick connect chuck and pull it against the driver. 2. Insert the bit into the chuck. 3. The collar will return to its original position when it is released. 4. Pull the bit to make sure it does not come out. 5. To remove the bit, pull back on the collar in the same way. CAUTION: • If the collar does not return to its original position or the bit comes out when pulled on, the bit has not been properly attached. Make sure the bit is properly attached before use. Use 6.35mm (1/4") hexagonal bits. To ensure proper securement of the bit, use only hexagonal bits with 9.5mm (3/8") detent. 6.35mm (1/4") 9.5mm (3/8") Attaching or removing battery pack 1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. 2. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body. V. OPERATION Switch and Forward / Reverse lever Operation CAUTION: • To prevent damage, do not operate Forward/Reverse lever until the bit comes to (Forward, Lock, Reverse) a complete stop. Forward Rotation Switch Operation 1. Push the lever for forward rotation. 2. Depress the trigger switch slightly to start the tool slowly. 3. The speed increases with the amount of depression of the trigger for efficient tightening of screws. The brake operates and the bit stops immediately when the trigger is released. 4. After use, set the lever to its center position (switch lock). Reverse Rotation Switch Operation 1. Push the lever for reverse rotation. Check the direction of rotation before use. 2. Depress the trigger switch slightly to start the tool slowly. 3. After use, set the lever to its center position (switch lock). CAUTION: • To eliminate excessive temperature increase of the tool surface, do not operate the tool continuously using two or more battery packs. Tool needs cool off time before switching to another pack. LED light CAUTION: • The built-in LED light is designed to illuminate the small work area temporarily. • Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. Depress the trigger switch, then LED light turns on. When the trigger switch is released, the light turns off automatically. - 6 -