Panasonic EY7540 EY7540 User Guide - Page 8
To Change the Belt Hook, Location Side, Control Panel - impact driver
View all Panasonic EY7540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Release the belt hook lock lever to lock the angle of belt hook. 4. Make sure the belt hook is firmly locked. Also make sure the belt hook is firmly locked into position 3. • The belt hook cannot be locked in this position. Firmly lock it into position before use. To return the belt hook to the storing position, Follow step 1. and 2. above, then lower the belt hook. To secure the lock, follow 3 and 4 above. To Change the Belt Hook Location Side The belt hook can be attached to either side of the unit. 1. Set the belt hook at storing position. 2. Loosen the screw turning it counter- clockwise, using a flat metal or a flat blade screw driver. 3. Take out the belt hook and insert into the other side of the slot on the main unit. 4. Fasten the screw firmly, turning it clockwise. The belt hook can be taken out from the main unit only when it is at storing position. Control Panel (4) (3) (1) (2) (1) Impact Power Mode Select Selecting the impact power among 3 modes (Soft, Medium, Hard). Press the impact power mode button to set it. The mode changes to hard, medium, or soft each time the button is pressed. The driver is preset to "hard" impact mode setting when shipped from the manufacturer. Recommended work guideline table Impact Power mode Display Recommended Application H 0 - 2300 r.p.m. and 0 - 3000 i.p.m. Jobs requiring a high level of torque where there is no possibility of the screw breaking, its top shearing off, or the bit coming loose. (This setting provides maximum torque.) Suitable applications include: Tightening M8 and larger bolts Tightening long screws during interior finishing work M 0 - 1400 r.p.m. and 0 - 2800 i.p.m. S 0 - 1000 r.p.m. and 0 - 2000 i.p.m. Jobs requiring limited torque where there is a possibility of the screw breaking or its top shearing off. (This setting limits torque.) Suitable applications include: Tightening bolts with smaller diameters (M6) Tightening metalwork screws when installing fixtures Jobs requiring limited torque where there is a possibility of the screw breaking, its top shearing off, or the bit coming loose and damaging a finished exterior surface. (This setting limits torque.) Suitable applications include: Tightening bolts smaller than M6 that may shear easily Tightening screws into molded plastic Installing gypsum wallboard * i.p.m. = Impact per minute. (2) LED light Pressing the button toggles the LED light on and off. The light illuminates with very low current, and it does not adversely affect the performance of the driver during use or its battery capacity. CAUTION: • The built-in LED light is designed to illuminate the small work area temporarily. • Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. This product has the built-in LED light. - -