Panasonic FV05VQ3 Installation Instructions - Page 8
the suspension
View all Panasonic FV05VQ3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALLATION I (JOIST MOUNTING-I) CONTINUED 8. Finish ceiling work. Ceiling hole should be aligned with the edge of the flange. (Fig.6) 0 ipe (2-15) 9. Insert mounting springs into slots as shown and mount grille to fan body. (Fig.7) Note: Suitable for use with solid-state speed controls. Solid-state speed controls may cause harmonic distortion which can cause a motor humming noise. 0 / Ceiling inches (mm) Slot Ceiling Fig. 6 Mounting spring Grille Fig. 7 INSTALLATION II (JOIST MOUNTING-II) 1. Open the orifice cover, disconnect plug connector from receptacle and remove adaptor from fan body before starting installation. 2. Insert the suspension bracket into the adaptor and secure it to joists by using long screw (ST4.2X20). (Fig.8) Ensure that distance B (7/8 inch, 21.6mm) for the thickness of ceiling board. If spacing A between joists is 21 1/4 to 23 1/2 inches (540-597mm), connect suspension bracket II and DI (C4 mark to C4 mark) according to page 6. Select the suspension bracket according to spacing A as shown below. Spacing A Joi is inches (nmm) 13 1/4-151/2 (336-394) suspension bracket suspension bracket I 16 1/2-18 3/4 (419-480) suspension bracket III 21 1/4-23 1/2 (540-597) suspension bracket II&III 3. Follow step 5 to 7 of the installation I (page 7) to complete the duct work and wiring. 4. Insert the suspension bracket into fan body (refering to step 2 of installation I, page 6) C"\ Adaptor II r\\ 2 Long screws (ST4.2X20) Joists fi 2 Long screws (ST4.2X20) Adaptor Suspension bracket 13 1/4-15 1/2 ( 336-394 ) 1(3 1/2-19 3/4 (419-480) 21 1/4-23 1/2 ( 540-597 ) A inches (mm) 7/8 (21,6) Fig. 8 8