Panasonic HMTA2 HMTA2 User Guide - Page 82

≥ Do not leave rubber or plastic products in contact with the unit for a long time. When you use the unit in a sandy or dusty place such as a beach, do not let sand or fine dust get into the body and terminals of the unit. ≥ Sand or dust may damage the unit. (Care should be taken when inserting and removing a card.) HM-TA2 Keep the unit away from sea water. ≥ If sea water splashes onto the unit, wipe off the water with a well wrung cloth. Then wipe the unit again with a dry cloth. Do not use the unit for surveillance purposes or other business uses. ≥ In certain situations, continuous use could cause the unit to overheat and cause a malfunction. Such use is strongly discouraged. ≥ This unit was designed for consumer intermittent use. It was not intended for continuous use, or for any industrial or commercial application resulting in prolonged use. Perform a formatting of the built-in memory when this unit is to be disposed/transferred. (l 57) About status indicator during charging When the status indicator is flashing at a particularly fast rate, the following should be considered. Flashing with approx. 2 second period (off for approx. 1 second, on for approx. 1 second): ≥ The battery is not charged. Press the RESET button, and try charging again. ≥ Check that the terminals of the unit are not dirty or covered with a foreign object, and connect this unit correctly once again. If a foreign object or dirt is present, turn off the unit and then remove it. ≥ The battery or environment is at an extremely high or low temperature. Wait until the temperature has returned to an appropriate level and try charging again. If you are still unable to charge, there may be a fault in this unit. 82 VQT3N87