Panasonic KX-TG524 KX-TG5240 KX-TG5243 Operating Instructions - Page 86
The Caller ID Number Auto Edit feature is
View all Panasonic KX-TG524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
TG5240.fm Page 86 Wednesday, September 22, 2004 3:45 PM Troubleshooting Problem The handset and/or base unit does not announce the displayed caller's name. The handset and/or base unit does not announce the displayed caller's name properly. The handset cannot automatically edit the Caller List/incoming phone numbers. The handset display exits the Caller List or phone book. The Ringer/Message Alert indicator flashes slowly when the handset is not ringing and in use. You cannot have a conversation using the headset. Cause & Remedy • The handset and/or base unit ringer volumes are turned off. Set to high, medium, or low (p. 20, 21). • The Talking Caller ID feature is turned off. Turn it on (p. 33, 34). • Name pronunciation may vary. Name pronunciation quality is based on names most commonly used in the United States. • The handset and/or base unit will announce each letter of abbreviations, such as "Co." and "Inc.". • Caller ID supports names of up to 15 letters. If the caller's name has more than 15 letters, the name will not be announced correctly. • The Caller ID Number Auto Edit feature is turned off. Turn it on (p. 37) and try again. • You need to press [C] or [s] after editing the number. • Do not pause for over 60 seconds while searching. • The Message Alert is turned on and new messages have been recorded. Turn the Message Alert off (p. 26) or listen to the new messages (p. 64, 65, 70). • Make sure the optional headset is connected properly (p. 77). • If "SP-phone" is displayed on the handset, press [C] to switch to the headset. 86