Panasonic KY-B84 Installation Instructions - Page 5

Electrical Work WARNING Electrical work must be performed by a legally qualified electrician. ■■ Electrical requirements -- This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse. (The rating plate is on the bottom of the appliance.) -- Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. -- You must use a three-wire, single-phase A.C. 240 V, 40 A, 60 Hz electrical system. If you connect to aluminum wiring, properly use connectors approved for use with aluminum wiring. -- Check with the local utilities for electrical codes applied in the area. Failure to wire the appliance according to governing codes may result in a hazardous condition. If there are no local codes, the appliance must be wired and fused to meet the requirements of CSA and CEC. -- After installation, show the customer where the breaker for the appliance is located. ■■ Installation of the earth leakage circuit breaker -- In accordance with the electrical wiring rules, incorporate the earth leakage circuit breaker in the home electrical wire. -- Follow the specification of the earth leakage circuit breaker as follows. Rated current: 40 A, rated sensitivity current: 30 mA ■■ Electrical connections 1. Turn off power. Turn off power at the circuit breaker or remove fuses to the appliance branch circuit. 2. Connect the power cord. Connect the power cord in accordance with all governing codes and ordinances. Connect to the ground terminal. E L2 L1 Connect to the line terminal. Yellow / Green Black Red CAUTION For your safety, remove the plastic cover from the power cord before performing electrical work. 8 Installing the Appliance WARNING Do not disassemble the top plate. Connected wire may become loose and cause a malfunction. 1. Fasten the clamps to the main unit (4 places on the front and back). -- Put the Cardboard A underneath the main unit to act as a buffer in order to prevent the countertop from getting damaged. -- Match the clamp grips with the holes on the sides of the main unit, then slide the clamp from the right to the left to fasten them to the main unit. Cardboard A 2. Embed the main unit in the countertop cutout while keeping it is as level as possible. -- Do not drop the unit on the countertop. -- Press down on top of the main unit to make sure that the frame is solidly rest on the countertop. -- Make sure that the spaces between the countertop and the under surface of the top frame are even in the front, back, left and right. Correct Incorrect 3. Connect the power cord See page 8. CAUTION If the cabinet does not have an opening in the front, the wiring needs to be connected before the main unit is embedded into the countertop. 9