Panasonic MC-BU100-S MC-BU100-S Owner s Manual - Page 28

Warning - review

Get Panasonic MC-BU100-S PDF manuals and user guides View all Panasonic MC-BU100-S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

BEFORE REQUESTING SERVICE WARNING Electrical Shock or Personal Injury Hazard Disconnect the electrical supply before servicing or cleaning the vacuum cleaner. Failure to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting. Review this chart to find do-it-yourself solutions for minor performance problems. Any service needed, other than those described in these Operating Instructions, should be performed by an authorized service representative. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Vacuum Cleaner won't run. 1. ON/OFF button not turned on. 1. Push ON/OFF button to on. 2. Battery is dead. 2. Charge Battery Poor job of dirt pick-up. 1. Full or clogged dust bin. 2. Dirty filters. 3. Clogged nozzle or dust bin. 4. Overload proctector activated. 5. Worn agitator. 1. Empty dust bin. 2. Change/clean filters. 3. Clean nozzle or dust bin. 4. Turn off for 10 seconds, and then turn back on. 5. Replace agitator. Agitator not turning. 1. Overload proctector activated. 2. Belt/agitator not installed properly. 1. Turn off for 10 seconds, and then turn back on. 2. Check belt and/or agitator. - 28 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Vacuum Cleaner
1.
ON/OFF button not turned on.
1.
Push ON/OFF button to on.
won’t run.
2.
Battery is dead.
2.
Charge Battery
Poor job of dirt
1.
Full or clogged dust bin.
1.
Empty dust bin.
pick-up.
2.
Dirty filters.
2.
Change/clean filters.
3.
Clogged nozzle or dust bin.
3.
Clean nozzle or dust bin.
4.
Overload proctector activated.
4.
Turn off for 10 seconds, and
then turn back on.
5.
Worn agitator.
5.
Replace agitator.
Agitator not turning.
1.
Overload proctector activated.
1.
Turn off for 10 seconds, and
then turn back on.
2.
Belt/agitator not installed
2.
Check belt and/or agitator.
properly.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum
cleaner suddenly starting.
BEFORE REQUESTING SERVICE
- 28 -