Panasonic NN-CS597 Operating Instructions - Page 42
Before Requesting Service
View all Panasonic NN-CS597 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Before Requesting Service The oven causes interference with my TV. Steam accumulates on the oven door and warm air comes from the oven vents. These things are normal: Some radio and TV interference might occur when you cook with the microwave oven. This interference is similar to the interference caused by small appliances such as mixers, vacuums, blow dryers, etc. It does not indicate a problem with your oven. During cooking, steam and warm air are given off from the food. Most of the steam and warm air are removed from the oven by the air which circulates in the oven cavity. However, some steam will condense on cooler surfaces such as the oven door. This is normal. After use, the oven should be wiped dry (see page 39). PROBLEM Oven will not turn on. Oven will not start cooking. The word "LOCK" appears in the Display Window. The oven stops cooking by microwave and "H97" or "H98" appears in the display window. "DEMO MODE PRESS ANY KEY" appears in the display window. The fan motor continue operating after cooking is over. IP1479_38S71CP_Eng_02_071107.indd Sec1:40 POSSIBLE CAUSE REMEDY The oven is not plugged in securely. Main circuit breaker or main fuse is tripped or blown. There is a problem with the outlet. Oven Circuit Breaker is tripped. Remove plug from outlet, wait 10 seconds and re-insert. Reset main circuit breaker or replace main fuse. Plug another appliance into the outlet to check if it is working. Reset Oven Circuit Breaker to "I" position. The door is not closed completely. Close the oven door securely. Start button was not pressed after programming. Press Start button. Another program is already entered into the oven. Press Stop/Reset Pad to cancel the previous program and enter new program. The program is not correct. Program again according to the Operating Instructions. Stop/Reset Pad has been pressed accidentally. Program oven again. The CHILD SAFETY LOCK was activated by pressing Start button 3 times. Deactivate LOCK by pressing Stop/ Reset pad 3 times. This displaying indicates a problem with Please contact an authorised Service the microwave generation system. Centre (see page 41). The oven is in demonstration mode. The fan motor is cooling the electric components. Press Timer/Clock pad 4 times to exit the mode. It is normal. 40 2007-11-7 @Tom@ 11:34:05