Panasonic NN-SE284 Cut Out Template - Page 1
Panasonic NN-SE284 Manual
View all Panasonic NN-SE284 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
A Drill a 1/2" dia. hole. Upper-Cabinet Template 13/8"(35.7mm) ŒThis product must be mounted against and supported by both a flat vertical wall and an upper cabinet or other horizontal structure. Proper installation of this product requires that the product is installed directly above the mount location. Reinforcing this bottom might be necessary if the cabinet cannot support a weight of 77 lbs. (35.0kg). Read installation instructions carefully to safely install this product. 1317/32"(343.8mm) 815/16"(227mm) Center line CUT OUT FOR POWER SUPPLY CORD 19 /50" ( 3 0 m m) 17/16"(36mm) A Drill a 1/2" dia. hole. 2"(50mm) 11/2"(39mm) 1313/32"(340.5mm) 9"(229mm) Left side Right side Rear wall Drill a 1/8" dia. hole if hole is over a wall stud. Drill a 5/8" dia. hole if hole is away from a wall stud. location location 31/4"(83mm) 4"(102mm) CUT OUT FOR TOP EXHAUST Select the ventilation type you need. Only cut this area if you select top exhaust. Follow the installation instruction for appropriate preparation. 123/8"(314mm) CUT OUT FOR REAR EXHAUST Select the ventilation type you need. Only cut this area if you select rear Follow the installation instruction for appropriate preparation. 101/4"(260mm) exhaust. Wall Template ŒMinimum height (see installation instructions) from cooking surface (or countertop) to top plate of microwave oven Œ30" minimum cabinet opening is required. Center line Rear wall Drill a 1/8" dia. hole if hole is over a wall stud. Drill a 5/8" dia. hole if hole is away from a wall stud. location location F04318Q02CP