Panasonic PT AE4000U Lcd Projector - Page 11

Preparation Preparation About Your Projector Remote control Power button While MAIN POWER is on, switch between standby mode and projection mode. Remote control signal emitter Emit remote control signal. Display the PICTURE menu or ADVANCED MENU. Switch to cycle through the PICTURE MODE. Display the VIERA LINK menu. Display the main menu or return to the previous menu. Navigate through the menus with and activate the menu item with the ENTER button. Open the connected equipment menu while using the VIERA Link. Switch to cycle through the input method. Battery compartment 111 Press the tab and lift up the cover. 222 Insert the batteries according to the polarity diagram indicated inside. Button backlight When any button is pressed, the button backlight is lit. Without any operation, it gets darker after 5 seconds and goes off after next 5 seconds. Display the ZOOM/FOCUS menu. Display the MEMORY LOAD menu. Capture the projected image as a still image. Display the input waveform. Reset some of the settings to the factory default. Return to the previous menu. Activate the assigned function from the menu options for shortcut. Note: •• See the functional instructions that is in the provided CD-ROM for more details. •• Do not drop the remote control. •• Avoid contact with liquids or moisture. •• Use manganese batteries or alkaline batteries with the remote control. •• Do not attempt to modify or disassemble the remote control. Contact an Authorized Service Center for repairs. •• Do not keep pressing the remote control buttons as this may shorten battery life. ENGLISH - 11