Panasonic PT-AR100 Operating Instructions - Page 71
Maintenance, TEMP and LAMP Indicators, Managing the indicated problems
![]() |
View all Panasonic PT-AR100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
TEMP and LAMP IndicatoTrEsMP and LAMP Indicators Managing the indicated problems If a problem should occur with the projector, the lamp indicator and/or temperature indicator will illuminate or flash. Check the indicator status and deal with problems as follows. Attention zzWhen switching off power to deal with problems, ensure that you follow the procedure in "Switching off the power". ( page 29) Note zzCheck the status of the power supply with the power indicator . ( page 27)  Temperature indicator Lamp indicator ■■Temperature indicator Indicator status Problem Cause Solution zzIlluminates red during projection. (Alert indicating [REFER TO THE "TEMP indicator" SECTION IN THE OPERATION MANUAL.] is displayed.) zzFlashing red when power is turned off (projection stops automatically). The temperature inside and/or outside the projector is abnormally high. The air intake and The room exhaust ports may temperature may be obstructed. be too high. The air filter unit may be excessively dirty and ventilation may be poor. The projector may be being used at high elevations (1 400 m or more above sea level). Remove object(s) from the ventilation ports or clear the area around the projector. Place the projector in an environment with temperature and humidity as designated in the specifications. ( page 90) Clean or replace the air filter unit. ( page 73) The projector can only be used for two minutes after turning on. Set [HIGH ALTITUDE MODE] to [ON] within two minutes of turning the projector on. ( page 66) Note zzIf the indicator is illuminated or flashes despite taking the actions above, please contact your dealer to have your projector repaired. Maintenance ENGLISH - 71
![](/manual_guide/products/panasonic-ptar100-operating-instructions-4ffc8af/71.png)