Panasonic PT-LB2 Operating Instructions - Page 11

Using WebBrowser (cont.) Monitor information window This page indicates the projector status. To access this page from other pages, click [Status] in the main menu (at the left of the window). „„Projector status On this window, click the [Projector status] tab. „„Network status On this window, click the [Network status] tab. The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] → [Refresh]. If [SELF TEST Error (Detail)] appears on the Monitor information window, click it to view the error details. „„If [FAILED] appears Item MAIN CPU BUS FAN INPUT AIR TEMPERATURE OUTPUT AIR TEMPERATURE LAMP REMAIN TIME LAMP STATUS INPUT AIR TEMP.SENSOR OUTPUT AIR TEMP.SENSOR BATTERY AIR FILTER Description There is a problem with a microcontroller circuit. Contact your dealer. There is a problem with the fan or fan drive circuit. Contact your dealer. Input air temperature is high. The projector is likely being used in a high temperature environment such as near heating equipment. Temperature surrounding the lamp is high. The exhaust vent is likely blocked. The lamp has been used for longer than its rated useful life, and it is time to replace it. The lamp could not be lit. Allow the bulb of the light source to cool, and then turn on the projector. There is a problem with the air intake temperature sensor. Contact your dealer. There is a problem with the exhaust temperature sensor. Contact your dealer. The battery must be replaced. Contact your dealer. The remaining filter gets low. For further detail, see the Basic Manual. 11