Panasonic PT4743G PT4743G User Guide - Page 29
SET UP cont.
View all Panasonic PT4743G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
SET UP (cont.) r CONVERGE (cont.) Note: After selecting, press VOL u to activate RESET TO DEFAULT feature. When using this feature in Zoom mode, the effect can only be verified when you exit all menus and display normal picture. IC ON MENUS OPERATION NINE POINT CONVERGENCE CORRECTION Note: Remote Control must be in TV mode. Procedure ACTION • Press to display red correction screen. • Press the 1 through 9 keypad buttons on the remote control to select the desired convergence position. • Use the navigation buttons to align the RED cross with the white cross pattern. Note: An adjusted cross pattern appears white with a minimum of color protrusion. CONVERGENCE ADJ. Procedure • After pressing VOL u the align Green to Center screen will be displayed. • Then use the navigation buttons on the remote control to align the horizontal and vertical green lines on screen, with the cabinet reference marks on top center and left center of cabinet, as shown below. Reference Marks • Press "0" on the remote control keypad to display the BLUE correction screen, then repeat procedure. Press "0" Front of cabinet ACTION • Press to display red center correction screen. • • Note: Use the navigation buttons on the remote control to align the red cross with the white cross pattern at the center of the screen. Note: To prevent picture tube damage do not leave test pattern on for an extended period of time. Then press "0" on the remote control keypad to display the BLUE center correction screen, repeat procedure for adjusting blue. If needed press "0" again to return to RED correction screen. An adjusted cross pattern appears white with a minimum of color protrusion. Press "0" • To exit press ACTION repeatedly, then press CH p. r OTHER ADJ. Highlight OTHER ADJ. and press VOL u to enter sub submenu field. Note: While sub sub-menu features are highlighted, press VOL u to adjust or activate. • MODE - To select TV (antenna) or CABLE mode depending on the signal source. • AUTO PROGRAM - To automatically program all channels with a signal. • MANUAL PROGRAM - To manually add or delete channels. • AUTO POWER ON - Select SET to power up the TV at the same time as the Cable box or other components or select OFF. • CHAN BANNER - Select ON to display onscreen banner when changing channels. • IMAGE SHIFT - Selecting ON is recommended for this feature to prevent image retention on screen. 27 l