Panasonic PT47WX54J PT47WX34 User Guide - Page 7
Installation - parts
View all Panasonic PT47WX54J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH Installation Television Location This unit can be used as part of an entertainment center. Consult your dealer for available options. • Avoid excessive sunlight or bright lights, including reflections. • Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure. • Fluorescent lighting may reduce remote control transmitting range. • Keep away from magnetic equipment, including motors, fans and external speakers. Optional Cable Connections Shielded audio and video cables should be used between components. For best results: • Use 75-ohm coaxial shielded cables. • Use appropriate input and output connectors, that match your component connectors. • Avoid long cables to minimize interference. AC Power Supply Cord CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS. Cable / Antenna Connection For proper reception, either a cable or antenna connection is required. Cable Connection Incoming Cable from Connect the cable supplied by your local Cable Company cable company to ANT1 connection on back of television. Select ANT1 and Cable mode in SET UP menu. Note: A cable converter box may be required for proper reception. 75 Ohm VHF/UHF on back of TV Check with your local cable company for compatibility requirements. Antenna Connection For proper reception of VHF/UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. • Connect home antenna to ANT1 Incoming Cable from connection on back of television. Home Antenna Select ANT1 and TV mode in the SET UP menu. Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode and ANT 1 in the Set Up menu. INSTALLATION Remote Control Battery Installation Requires two AA batteries (supplied). Battery Polarity AA / 1.5A 1 2 AA / 1.5A AA / 1.5A AA / 1.5A 3 Procedure 1. Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated. 2. Install batteries matching (+) and (-) polarity signs. 3. Replace the battery cover by sliding in reverse until the lock snaps. Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control. Precautions • Replace batteries in pairs. • Do not mix battery types (zinc carbon with alkaline). • Do not recharge, heat, short-circuit, disassemble, or burn batteries. 5 z