Panasonic PTF100NTU PTF100NTU User Guide - Page 34

POSITION menu Remote control Control panel See "Navigating through the MENU" on page 29. See "Main menu and Sub-menu" on page 30. DOT CLOCK If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing I H to adjust the clock frequency. KEYSTONE If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can correct keystone. Image Operation NOTE: • If the projecting signal's dot clock frequency is higher than 108 MHz, the adjustment may not make a difference. • DOT CLOCK needs to be adjusted before adjusting the CLOCK PHASE. CLOCK PHASE If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust. Setting range: -32 to +32 NOTE: • You can correct the distortion ± 30 degrees from the plane. For a better quality image, installing the projector with a minimum of distortion is recommended. • Some distortion may be retained for lens shift adjustment. • The distortion of the Main menu screen is not correctable. • The result of the keystone correction will affect the aspect ratio and the size of the image. POSITION You can move the projected image for fine adjustment. Press I H to move horizontally and F G vertically. NOTE: • If the projecting signal's dot clock frequency is higher than 108 MHz, the adjustment may not make a difference. • CLOCK PHASE is available with PC signals and the following COMPONENT connection. ASPECT You can switch the aspect ratio manually when needed. Press I H to cycle through the options. 4:3 AUTO 16:9 S4:3 Q 4:3 The input signal will be projected without any change. POSITION H V Settings ENGLISH - 34