Panasonic PTST10U PTST10U User Guide - Page 7
Cautions When Transporting, Be Sure To Ask A Specialized
UPC - 885170015180
View all Panasonic PTST10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Essential information Precautions with regard to safety (continued) ON USE/INSTALLATION Do not put your weight on this projector. You could fall or the projector could break, and injury will result. • Be especially careful not to let young children stand or sit on the projector. Do not place the projector in extremely hot locations. Doing so will cause the outer casing or internal components to deteriorate, or result in fire. • Take particular care in locations exposed to direct sunlight or near stoves. Always disconnect all cables before moving the projector. Moving the projector with cables still attached can damage the cables, which will cause fire or electric shocks to occur. ACCESSORIES Do not use the old lamp unit. If used it could cause lamp explosion. If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces. Failure to observe this will cause the user to absorb the gas which was released when the lamp broke and which contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces will cause injury. If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical advice immediately. Ask your dealer about replacing the lamp unit and check the inside of the projector. CAUTIONS WHEN TRANSPORTING When transporting the projector, the leg adjusters must be housed and do not hold them. When transporting, keep the projector with the lens cover on it. • Please take care to keep them away from vibration and impacts, both the projector and the lens are precision-made and easily susceptible to damage. CAUTIONS WHEN INSTALLING DO NOT USE UNDER THE FOLLOWING CONDITIONS. • Do not set up the projector outdoors. The projector is designed for indoor use only. • Avoid setting up in places which are subject to vibration or shocks. If the projector is installed in a place where vibrations are transmitted or mounted in a car or a vessel, vibrations or impacts will result in damage to the internal parts, causing failure. Install the product in a place free from vibrations and impacts. • Avoid setting up in places which are subject to sudden temperature changes, such as near an air conditioner or lighting equipment. Failure to observe this will result in malfunctions or the lamp life will be shortened. See "TEMP INDICATOR" on page 43. • Avoid setting up in places which are near highvoltage power lines or near motors. The product will be exposed to interference if it is installed in the vicinity of high-voltage electrical power lines or power sources. • Do not install the projector at elevations higher than 2 700 m (8 858 ft) above sea level. If using this projector at high elevations 1 400 2 700 m (4 593 - 8 858 ft) above sea level, set the HIGH ALTITUDE MODE to ON. If using this projector at elevations lower than 1 400 m (4 593 ft) above sea level, set the HIGH ALTITUDE MODE to OFF. Failure to observe this will result in malfunctions or the lamp life or life of other components will be shortened. BE SURE TO ASK A SPECIALIZED TECHNICIAN WHEN INSTALLING THE PRODUCT TO A CEILING. If the product is to be installed hanging from the ceiling, purchase an optional hanging attachment (Model No. ET-PKB2). Please call a specialized technician or contact an Authorized Service Center for installation. LENS FOCUS Do not adjust the lens focus in the initial period after switching the projector on. The high clarity projector lens is thermally affected by the light from the light source, making the focus unstable in the period just after switching on. Please allow a warm-up time of at least 30 minutes before adjusting the lens focus. ENGLISH 7